Epson WorkForce ST-M1000 Start Here - Installation Guide - Page 1

ST-M1000 Start Here IMPORTANT: Before using this product, make sure you read these instructions and the safety instructions in the online User's Guide. 1 Unpack 2 Fill ink tank and charge the ink Warning: Keep the ink bottle out of the reach of children and do not drink the ink. Caution: This product requires careful handling of ink. If ink spills, wipe it off immediately with a damp towel to avoid permanent stains. If ink gets on your clothes or belongings, it may not come off. Note: • Epson cannot guarantee the quality or reliability of third-party ink. • Use the ink bottle included with the printer to set up the product. Part of the ink will be used to charge the print head. This bottle may print fewer pages compared with replacement ink bottles. 1 Open the ink tank cover, then open the cap. Note: Do not open the ink bottle until you are ready to fill the ink tank. The ink bottle is vacuum packed to maintain reliability. 1 Remove all protective materials from the product. 2 Unpack the ink bottle. Hold the ink bottle upright and slowly turn the bottle cap to remove it. Caution: Do not touch the flat white cable, translucent film, or the ink tubes. 2 Close the printer cover until it clicks. Caution: Do not shake or squeeze the ink bottle. Do not touch the top of the ink bottle after its cap is removed. 3 Insert the ink bottle into the filling port, as shown below. Note: Do not connect the power cord yet. Note: Do not force the bottle into position. 4 Wait for the ink to fill the tank. Do not squeeze the bottle. Note: If ink does not flow from the bottle, lift and reinsert the bottle.