Fagor 24 Inch Beverage Center User's Manual - Page 7

ELECTRICAL CONNECTION Check that the voltage marked on the product corresponds with your supply voltage. Improper use of the grounded plug can result in the risk of electric shock. If the power cord is damaged, have it replaced by a qualified electrician or an authorized service center. This appliance should be properly grounded for your safety. The power cord of this appliance is equipped with a three-prong plug which is compatible with standard three-prong wall outlets to minimize the possibility of electric shock. Do not under any circumstances cut or remove the third (ground) prong from the power cord supplied. For personal safety, this appliance must be properly grounded. This appliance requires a standard 115/120 Volt AC ~ 60Hz three-prong grounded electrical outlet. Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded. When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet. To prevent accidental injury, the cord should be secured behind the appliance and not left exposed or dangling. The appliance should always be plugged into its own individual electrical outlet that has a voltage rating that matches the rating label on the appliance. This provides the best performance and also prevents overloading house wiring circuits that could cause a fire hazard from overheating. Never unplug the appliance by pulling on the power cord. Always grip the plug firmly and pull straight out from the outlet. Immediately repair or replace all power cords that have become frayed or otherwise damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end. When moving the appliance, be careful not to damage the power cord. EXTENSION CORD Because of potential safety hazards under certain conditions, it is strongly recommended that you do not use an extension cord with this appliance. However, if you must use an extension cord it is absolutely necessary that it be a UL/CUL-Listed, 3wire grounding type appliance extension cord having a grounding type plug and outlet and that the electrical rating of the cord be 115 volts and at least 10 amps. INSTALLING THE HANDLE IMPORTANT: Do not over tighten the screws and do not use power tools to install the handle. 1 2 4 3 5 1. Remove the door gasket ○1 on the side you E A wish to install the handle - you can see two designated holes for handle installation. 2. Install the handle ○4 tightly as shown above A E A with two screws ○3 and flat washers ○2 A E A A E A provided. 3. Replace the door gasket. THIS APPLIANCE MUST BE EARTHED. 7