Fellowes 225Mi Manual - Page 2

ENGLISH Model 225Mi A. H. B. I. C. KEY J. A. SafeSense® Technology H. Disconnect power switch J. Control Panel and LEDs D. B. Paper/card entry 1. OFF 1. Reverse E. C. CD entry 2. ON 2. ON/OFF F. D. Door I. See safety instructions 3. Forward E. Basket (paper) 4. Auto F. Basket (CD) 5. Door open (red) G. Casters (4) 6. Bin full (red) 7. Remove paper (red) 8. SafeSense® indicator (yellow) G. CAPABILITIES Will shred: Paper, credit cards, CD/DVD, staples, small paper clips and junk mail Will not shred: Adhesive labels, continuous form paper, transparencies, newspaper, cardboard, large paper clips, folders, X-rays or plastic other than noted above Paper shred size: Micro-Cut 5/64 in. x 15/32 in. (2mm x 12mm) Maximum: Sheets per pass...14* CDs/Cards per pass 1* Paper entry width 9 1/2 in. (240mm) * 8.5"x11", 20lb., (75g) paper at 120V, 60 Hz, 6Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Maximum recommended daily usage rates: 3,000 sheets; 200 cards; 10 CDs. Fellowes SafeSense® shredders are designed to be operated in office environments ranging between 50 - 80 degrees Fahrenheit (10 - 26 degrees Celsius) and 40 - 80% relative humidity. IMPORTANT SAFETY INSTRUCTIONS - Read Before Using! • Operation, maintenance, and service requirements are covered in the instruction manual. Read the entire instruction manual before operating shredders. • This shredder has a Disconnect Power Switch (H) that must be in the ON (I) position to operate shredder. In case of emergency, move switch to OFF (O) position. This action will stop shredder immediately. • Keep away from children and pets. Keep hands away from paper • Avoid touching exposed cutting blades under shredder head. entry. Always set to off or unplug when not in use. • Use only designated entry for CDs/cards. Keep fingers away from CD entry. • Keep foreign objects - gloves, jewelry, clothing, hair, etc. - away • Do not put foreign objects in paper entry. from shredder openings. If object enters top opening, switch to 15 Reverse ( ) to back out object. • Shredder must be plugged into a properly grounded wall outlet or socket of the voltage and amperage designated on the label. The grounded outlet or • Never use aerosol products, petroleum based lubricants or other socket must be installed near the equipment and easily accessible. Energy 15 flammable products on or near shredder. Do not use canned air converters, transformers, or extension cords should not be used with on shredder. this product. • Do not use if damaged or defective. Do not disassemble shredder. • FIRE HAZARD - Do NOT shred greeting cards with sound chips or batteries. 15 Do not place near or over heat source or water. • For indoor use only. • Unplug shredder before cleaning or servicing.