Fellowes 450M Manual - Page 2

ENGLISH Model 450M G. A. B. C. KEY A. CD/card entry H. Control Panel and LEDs H. B. See safety instructions 1. Overheat (red) D. C. Paper entry 2. Remove paper (yellow) D. Pull-out bin 3. ON/OFF and Bin open (green) E. Window 4. Reverse E. F. Casters 5. Auto G. ON/OFF switch 6. Forward 1. OFF 2. ON F. CAPABILITIES Will shred: Paper, plastic credit cards, CD/DVDs and staples Will not shred: Adhesive labels, continous form paper, transparencies, newspaper, cardboard, laminates, paper clips, file folders, X-rays or plastic other than noted above Paper shred size: Micro-Cut 5/64 in. x 1/2 in. (2mm x 12mm) Card/CD shred size: Strip-Cut 9/16 in. (40mm) Maximum: Sheets per pass ...9* Cards/CDs per pass ...1* Paper entry width 8-7/10 in. (220mm) CD entry width 4-8/10 in. (122mm) *8.5 in. x11 in., 20lb., (75g) paper at 120V, 60 Hz, 2.5Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Maximum recommended daily usage rates: 300 sheets per day; 25 credit cards; 10 CDs. 9 sheets per pass to avoid jams. 15 15 2 IMPORTANT SAFETY INSTRUCTIONS - Read Before Using! • Operation, maintenance, and service requirements are covered in the instruction manual. Read the entire instruction manual before operating shredders. • Keep away from children and pets. Keep hands away from paper entry. Always set to off or unplug when not in use. • This shredder has an ON/OFF Switch (G) that must be in the ON (I) position to operate shredder. In case of emergency, move switch to OFF (O) position. This action will stop shredder immediately. • Avoid touching exposed cutting blades under shredder head. • Keep foreign objects - gloves, jewelry, clothing, hair, etc. - away from shredder • Shredder must be plugged into a properly grounded wall outlet or socket of the openings. If object enters top opening, switch to Reverse ( ) to back out object. voltage and amperage designated on the label. The grounded outlet or socket 15 • Never use aerosol products, petroleum based lubricants or other flammable products on or near shredder. Do not use canned air on shredder. must be installed near the equipment and easily accessible. Energy converters, transformers, or extension cords should not be used with this product. • Do not use if damaged or defective. Do not disassemble shredder. • FIRE HAZARD - Do NOT shred greeting cards with sound chips or batteries. Do not place near or over heat source or water. • For indoor use only. • Unplug shredder before cleaning or servicing.