Fellowes 73Ci Manual - Page 2

A. F. B. C. ENGLISH Model 73Ci G. KEY D. A. See safety instructions G. Control Panel and LEDs B. Paper entry 1. Reverse (blue) 6. SafeSense® indicator (yellow) C. SafeSense® Technology 2. ON/OFF (blue) 7. Remove Paper (red) D. Pullout bin 3. Forward (blue) 8. Overheat (red) E. Casters 4. Bin full (red) F. Disconnect power switch 5. Bin open (red) 1. OFF 2. ON G. E. • Control panel features multi-touch back-lit controls • When shredder is off, control panel will not be visible CAPABILITIES Will shred: Paper, credit cards, staples, small paper clips and CD/DVDs Will not shred: Adhesive labels, continous form paper, transparencies, newspaper, cardboard, large paper clips, laminates, file folders, X-rays or plastic other than noted above Paper shred size: Cross-Cut 5/32 in. x 1-1/2 in. (4mm x 38mm) Maximum: Sheets per pass...12* CDs/Cards per pass...1* Paper entry width 9" (230mm) *8.5"x11", 20lb., (75g) paper at 120V, 60 Hz, 4Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Recommended daily usage rates: 300 sheets, 25 credit cards; 10 CD/DVDs 12 sheets per pass. Fellowes SafeSense® shredders are designed to be operated in home and office environments ranging between 50 - 80 degrees Fahrenheit (10 - 26 degrees Celsius) and 40 - 80% relative humidity. IMPORTANT SAFETY INSTRUCTIONS - Read Before Using! • Operation, maintenance, and service requirements are covered in the instruction manual. Read the entire instruction manual before operating shredders. • Keep away from children and pets. Keep hands away from paper entry. Always set to off or unplug when not in use. • This shredder has a Disconnect Power Switch (F) that must be in the ON ( ) position to operate shredder. In case of emergency, move switch to OFF (O) position. This action will stop shredder immediately. • Avoid touching exposed cutting blades under shredder head. • Keep foreign objects - gloves, jewelry, clothing, hair, etc. - away from shredder • Shredder must be plugged into a properly grounded wall outlet or socket of the openings. If object enters top opening, switch to Reverse ( ) to back out object. voltage and amperage designated on the label. The grounded outlet or socket 15 • Never use aerosol products, petroleum based lubricants or other flammable products on or near shredder. Do not use canned air on shredder. must be installed near the equipment and easily accessible. Energy converters, transformers, or extension cords should not be used with this product. • Do not use if damaged or defective. Do not disassemble shredder. • FIRE HAZARD - Do NOT shred greeting cards with sound chips or batteries. 15 Do not place near or over heat source or water. • For indoor use only. 15 • Unplug shredder before cleaning or servicing. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Increase the separation between the equipment and receiver. • Consult the dealer or an experienced radio/TV technician for help. BASIC SET UP CASTER INSTALLATION 1 2 3 4 5 17 AUTO