Fellowes 73Ci Manual - Page 4
Limited Product Warranty - fellows paper shredder
View all Fellowes 73Ci manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
ENGLISH Model 73Ci PRODUCT MAINTENANCE OILING SHREDDER All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding, and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin. FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE 1 2 CLEANING AUTO-START INFRARED SENSORS Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run even if there is no paper present. (Note: two paper detection sensors are located in the center of the paper entry). TO CLEAN THE SENSORS 1 2 3 4 *Apply oil across entry Press and hold forward ( ) 2-3 seconds Turn off and unplug shredder Locate Auto-start infared sensor *Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250 Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers. 15 TROUBLESHOOTING Dip cotton swab in rubbing alcohol Using cotton swab, wipe away any contamination from the paper sensors Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will .not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder. Bin Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding. Bin Full: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 36052. Remove Paper: When illuminated, press reverse ( ) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry. SafeSense® Indicator: If hands are too close to the paper entry, the SafeSense® indicator will illuminate and the shredder will stop shredding. If SafeSense® is active for 3 seconds, the shredder will automatically turn off and the user must press the power button on the control panel to resume shredding. LIMITED PRODUCT WARRANTY Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of additional costs incurred by Fellowes to provide parts or services outside of the country where the defects in material and workmanship and provides service and support for 1 year from the date shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION be free from defects in material and workmanship for 5 years from the date of purchase by the TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable original consumer. If any part is found to be defective during the warranty period, your sole and for any consequential or incidental damages attributable to this product. This warranty gives you exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product except where different limitations, restrictions, or conditions may be required by local law. For usage standards, shredder operation using an improper power supply (other than listed on the more details or to obtain service under this warranty, please contact us or your dealer. label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any