Fender M-80 Preamp Owner Manual - Page 6
at0dBV
View all Fender M-80 Preamp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
LINE CORD Thk amplifier is Pqi lippari with a grni inriinn tuna ci mnly rnrn to rani ira tha pmsihiiitY of ieakagp ci irrant Pip sure to connect it to a grounded receptacle. Operation from an ungrounded (two pronged) AC receptacle requires a three to two contact grounding type adapter. Be sure to connect the adapter's grounding lead to a good earth ground. DO NOT ALTER THE AC PLUG. TROUBLESHOOTER'S CHECKLIST: If the amp is set up but does not function, check the following items: -Is the amp power cord properly plugged into an electrical outlet? - Is there power at the outlet? - Are all the control knobs turned up above four? - Is the volume control on the instrument turned up? - Is your instrument properly plugged into the amplifier? (Eliminate any effect pedals and try another guitar cord.) If, after checking all of the above, the system is still not performing correctly, consult your Fender Service Dealer. SPECIFICATIONS INPUT IMPEDANCE: OUTPUT IMPEDANCE: INPUT 1 only: Greater than 1 Meg Ohm. INPUT 2: 65k Ohm. LEFT OUTPUT 1k Ohm RIGHT OUTPUT 1k Ohm NOMINAL LEVEL: EFFECTS LOOP: (With output at"0"dBV) Gain Offset Max. POWER REQUIREMENTS: DIMENSIONS: SOUND: "KICKS*!". INPUT 1 only: 100 mV. INPUT 2: 200 mV. Nominal Level -4, +7, +16dBV. Send Impedance 3.9k Ohm Max. Input (Return) Impedance.. 41k Ohm. 120 Volts AC 60 Hz. .250 Amps Max., 30 Watts Max. HEIGHT: WIDTH (BODY): WIDTH (PANEL): DEPTH: WEIGHT: 1 23/32" (44cm) 17 1/8" 19" 5 1/2" 6 lbs.