Fender Mustang Mini Advanced Owner Manual - Page 3

MUSTANG™ MINI ♫ You can completely change the list of effects available on your Mustang Mini amplifier as well as access bonus effect parameters using Fender FUSE software! The three LEDs next to the EXIT button are numbered to indicate which effect position (1, 2 or 3) is being selected within each of the four selection ranges (A, B, C and D). For example, effect selection "A1" is shown below: 123 ♫ Press the TAP button just one time to set the delay or modulation interval to its maximum value. Guitar Tuner Your Mustang™ Mini amplifier has a built-in Tuner mode that uses the control panel LEDs as a chromatic guitar tuner. To use the tuner: 1. Press and hold the TAP button for 2 seconds. The TAP and EXIT buttons will illuminate. 2. Strike any single string on your guitar and watch the panel LEDs. The Preset LEDs are used to indicate the note of the string being tuned (the top LED "#" also lights up to indicate if the note is sharp). 3 LEDs indicate fine tuning. GREEN means "in tune" Effects Level To adjust the level of effects for the current preset, press and hold the EXIT button while turning the EFFECTS knob: Adjusting the EFFECTS level 123 Tap Button The TAP button can be used to tap in delay time and modulation rate settings for the current effect: • Delay time - TAP button blinks green: • Modulation rate - TAP button blinks red: When you select a delay type effect, the TAP button will blink green in sync with the delay time setting. When you select a modulation type effect, the TAP button will blink red in sync with the modulation rate setting. To set the TAP interval of effects: 1. Select an effect that causes the TAP button to blink, using the EFFECTS knob. 2. Press the TAP button twice rhythmically in time with the desired interval. Letters next to LEDs indicate the note being tuned 3. Turn the tuning peg on your guitar until the fine tuning LEDs next to the EXIT button indicate that the string is in tune, as shown above. 4. Standard guitar tuning is as follows: 5. Press EXIT or TAP to exit from the Tuner. fender.com 3