Fender Passport P150 Owners Manual - Page 10
Aux / Footswitch Jacks, Rear Panel
View all Fender Passport P150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
AUX / FOOTSWITCH JACKS A. AUX SEND - Plug your external effects signal processor in A B here. Although the Passport is already equipped with on-board digital reverb, an external effects signal processor can be incorporated into the Passport's signal flow. This 1/4 inch output jack is designed to feed the Passport's effects bus signal to an external signal processing device, such as a digital delay or a chorus unit. C. FOOT SWITCH - The C Footswitch connector allows the internal reverb return to be muted, or shut off, through the use of a simple foot operated switch. The footswitch should be wired to connect the tip to sleeve for Off and requires a standard speaker or instrument cable. B. AUX RETURN - Plug your external effects signal processor's output signal in here. This 1/4 inch input stereo jack is designed to accept signals from an external processing device, such as a digital delay or a chorus unit. This input can also be used as a stereo input with the volume controlled at the master volume knobs. REAR PANEL D. SPEAKER OUTPUTS - These are speaker level output jacks designed to feed each of your Passport speaker enclosures. Use the enclosed cables to connect the Passport's speakers to the power tower. SPEAKER OUTPUT LEFT D RIGHT E.POWER SWITCH - Turns the AC power ON and OFF. When the switch is in the OFF position, your Passport is completely shut down. OFF / ON F. LINE CORD - The F Passport is equipped with a grounding type IEC supply cord to reduce the possibility of shock hazard. Be sure to connect it to a grounded AC receptacle. DO NOT ALTER THE AC PLUG. 10