Fender The Twin Owner Manual - Page 4
additional - life
View all Fender The Twin manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
7 9 0 10 .U. KM POP' BASS 23 7 3 2 8 3 7 2 4 41 9 IU..1 KITH Cli.2 9 5 0 10 0 10 PUU. Y MOTO. PRESENCE PULL KM CH. Kt.. VOLUME REVERE LO NI OUTPUT STANDBY OFF ON POWER ® 0 CD L. BASS -Adjusts the amount of boost or cut in the low frequency range of Channel Two. This knob can be pulled out for additional bass boost. M. PRESENCE -Adjusts the amount of boost or cut in the upper high frequency range. This control occurs post preamp distortion and is useful in adjusting the distortion characteristic from brash, to smooth. This knob can be pulled out to activate the NOTCH mode which transforms the Presence control from a shelving type filter to a bandpass type, further adding to the sonic possibilities. N. VOLUME -Adjusts the overall loudness of Channel Two. This knob can be pulled out to select Ch. 2 when in the Channel-Switching mode. This pull switch disables the remote footswitch. O. REVERB SELECT SWITCH-This three position switch determines whether Channel One, Channel Two, or both channels have reverb. This control is used in conjunction with the Reverb control and the Reverb On/Off footswitch. P. REVERB-Adjusts the overall amount of reverberated signal mixed with the original dry signal. This control is disabled by the Reverb On/Off footswitch. O. OUTPUT SWITCH-Sets the maximum output of the amplifier to either HI -100 Watts R.M.S., or LO-25 Watts R.M.S. The HI setting is normally used for most applications and the LO position is useful in simulating a smaller amp especially with overdrive playing. R. STANDBY SWITCH -Turns the amplifier on and off, however while in the off position power is applied to the tube filaments so as to eliminate warm-up time when switched on. Use of this feature during periodic breaks vs. using the POWER ON/OFF SWITCH will increase tube life. S. POWER SWITCH -Turns AC power ON and OFF. When the switch is OFF the amplifier is completely shut down. T. POWER INDICATOR -When this indicator is illuminated the TWIN is receiving power.