Fisher and Paykel CDV2-365HN N Installation Guide - Page 15

Required Grounding Method

Get Fisher and Paykel CDV2-365HN N PDF manuals and user guides View all Fisher and Paykel CDV2-365HN N manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

INSTALLATION INSTRUCTIONS 13 US CA REQUIRED GROUNDING METHOD: This appliance is factory equipped with a power supply cord with a three-prong grounding plug (with polarized parallel blades) It must be plugged into a mating grounding-type receptacle, connected to a correctly polarized 120 Volt circuit. If the circuit does not have a grounding type receptacle, it is the responsibility and obligation of the installer or user to have the existing receptacle changed to a properly grounded and polarized receptacle in accordance with all applicable local codes and ordinances by a qualified electrician. In the absence of local codes and ordinances, the receptacle replacement shall be in accordance with the National Electrical Code. THE THIRD GROUND PRONG SHOULD NOT, UNDER ANY CIRCUMSTANCES, BE CUT OR REMOVED. The electrical supply must be a 120 volt, 60 Hz single phase, 15 AMP circuit. The power receptacle must be a NEMA 5-15R device to accept the three prong plug supplied with the unit. THIRD GROUND PRONG

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
13
US
CA
INSTALLATION INSTRUCTIONS
REQUIRED GROUNDING METHOD:
This appliance is factory equipped with a power supply cord with a three-prong grounding plug (with polarized
parallel blades) It must be plugged into a mating grounding-type receptacle, connected to a correctly polarized
120 Volt circuit. If the circuit does not have a grounding type receptacle, it is the responsibility and obligation
of the installer or user to have the existing receptacle changed to a properly grounded and polarized receptacle
in accordance with all applicable local codes and ordinances by a qualified electrician. In the absence of local
codes and ordinances, the receptacle replacement shall be in accordance with the National Electrical Code.
THE THIRD GROUND PRONG SHOULD NOT, UNDER ANY CIRCUMSTANCES, BE CUT OR REMOVED. The electrical
supply must be a 120 volt, 60 Hz single phase, 15 AMP circuit. The power receptacle must be a NEMA 5-15R
device to accept the three prong plug supplied with the unit.
THIRD GROUND PRONG