Fisher and Paykel RS36A72U1 Installation Manual - Page 17
Attach Anti-tip Bracket, Wooden/plaster Board, Wall Installation, Solid Wall Installation, Spacer - refrigerator
View all Fisher and Paykel RS36A72U1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
9 ATTACH ANTI-TIP BRACKET IMPORTANT! Safety requires refrigerators be stable when doors and/or drawer, are open. An anti-tip bracket and fittings supplied must be fitted to the wall of the finished enclosure to withstand a 220.5 pound (100 kg) load. This will prevent the possibility of the appliance tipping forward, when doors and/or drawer, are open. When fastening with masonry plugs and/or screws: ●● Ensure the screws avoid electrical, gas and water conduits. ●● Ensure the surface the bracket is fastened to withstand a 220.5 pound (100 kg) load. ●● Ensure light-weight masonry material such as cinder block and new concrete (no curing time) are not used in installation. ●● Do not use metallic materials that may corrode, stain and/or damage the enclosure. WOODEN/PLASTER BOARD WALL INSTALLATION SOLID WALL INSTALLATION SPACER INSTALLATION 1 Project the end of the above finished enclosure to the center of the back wall and subtract 1 ¼" (31 mm). This will locate the contact surface between the bracket and the appliance (refer to A). Ensure a structural beam/wall stud closest to the center of the wall enclosure is located. 1 Project the end of the above finished enclosure to the center of the back wall and subtract 1 ¼" (31 mm). This will locate the contact surface between the bracket and the appliance (refer to A). If a minimum 2 3/8" (60 mm) overlap cannot be achieved we recommend fastening a solid spacer (wooden beam etc) behind the bracket. 1 Ensure the length of the spacer corresponds to the enclosure's width. Always secure the spacer to existing studs on the enclosure wall (refer to C). 1 1/4" (31 mm) 2 3/8" min. (60 mm) overlap A Bracket PROFILE VIEW 2 Fix bracket to the wall with screws x4 (#10 x 40 pan head Phillips screw). Ensure screws hold tight and the bracket overlaps the appliance when it is positioned (2 3/8" min. (60 mm)) for a secure hold. 1 1/4" (31 mm) 2 3/8" min. (60 mm) overlap PROFILE VIEW A Bracket 1 1/4" (31 mm) 2 3/8" min. (60 mm) overlap Spacer C Bracket PROFILE VIEW 2 Mark screw locations to drill Ø ¼" x 1 ⅜" (Ø6.0 mm x 35 mm) deep holes. Hammer masonry plugs into the wall until flush x4. Fix bracket to the wall with screws x4 (#10 x 40 pan head Phillips screws). Ensure screws hold tight. 2 Fix bracket to the spacer with screws x4 (#10 x 40 pan head Phillips screws). Ensure screws hold tight and the bracket overlaps the appliance when it is positioned (2 3/8" min. (60 mm)) for a secure hold. 15