Fluke 2638A/05/C 120 Product Manual - Page 99
Firmware Update, return to a Fluke Calibration Service center to correct.
View all Fluke 2638A/05/C 120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
6 Maintenance and Care Firmware Update To Clear all Files: 1. Push . 2. Push . 3. Push . 4. Enter the Admin password, then push . 5. Push to confirm. To reset the Product to factory settings: 1. Push . 2. Push . 3. Enter the Admin password, then push . Firmware Update For Products with a firmware version 1.03 or higher, firmware may be updated by the product administrator with the front-panel USB port. New firmware versions are available from the Fluke Calibration web page for the Product under the Knowledge and Information tab. For Products that have firmware versions below 1.03, contact Fluke Calibration Service to schedule a firmware update as these versions do not support the USB firmware update process. Update instructions for Products that use version 1.03 and above: WCaution • Do not cycle the power or remove the USB device while the firmware update is in process. These actions will cause an instrument failure during the update process and require a return to a Fluke Calibration Service center to correct. • The Product automatically re-boots when the update process is complete. Updates can take several minutes to complete and the display screen will not illuminate until the re-boot. Note Fluke Calibration recommends that you move all internal data files and setup files from the Product to a USB device before the update of the firmware. Before the update process starts, verify that the current firmware is version 1.03 or above by viewing "Firmware" under . If your firmware version is below 1.03, do not continue the update process. You must return the Product to Fluke Calibration Service for the firmware update. 6-3 MyFlukeStore Shop for Fluke products online at: www. .com 1.877.766.5412