Fluke 700G07 Product Manual - Page 16
Operation
View all Fluke 700G07 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
700G Series Users Manual Operation The subsequent sections tell you how to operate the Product. Push to turn on the Product. The analog bar graph at the bottom of the display shows the applied-pressure level relative to the full range of the gauge. Note If you record a Tare value, the pressure shown is not the actual pressure applied. How to Setup the Product Before you use the product, it is necessary to configure it for your application. Push to go to the Setup menu. Each time is pushed, the display goes to the subsequent function. Push or to change the parameter value. When a parameter is set, push to exit the configuration menu or to move to the next parameter. Engineering Units The Product's default engineering unit shows psi. To change this, push and to move through the 23 standard engineering units plus one custom unit/scale. When the necessary unit shows, push or . Pressure now shows in the chosen engineering units. See the Specifications section for a list of available 8 engineering units. See the Supervisory Mode section for instructions to set up custom units. Set Auto Off Auto Off can be set in 1-minute increments from 1 to 30 minutes or you can turn off the function for continuous Product operation. The Product is configured for 30 minutes. Push and to set the necessary interval. The "off" position is at the low end of the selections, less than 1 minute. Show Battery Voltage Actual battery voltage and a percent-of-life bargraph show the battery charge. No adjustments are made in this parameter. Display Actual Temperature The Product is temperature compensated This parameter shows the temperature measured by the internal sensor. Push or to show degrees F or C. Set Damping Selections are "on" and "off" . Damping smooths readings from pulsating pressure sources. MyFlukeStore Shop for Fluke products online at: www. .com 1.888.610.7664