Home » Fluke Manuals » Electronics Accessories » Fluke BT510 » Manual Viewer

Fluke BT510 Product Manual - Page 44

View Profiles Saved in Sequence Mode, Confirm to delete the reading?, Delete, Delete all, VIEW memory

Add to My Manuals
Save this manual to your list of manuals

Page 44 highlights

BT510 Users Manual When the display shows Confirm to delete the reading?, push the Delete softkey. b. To delete all data in the measurement set, push the Delete all softkey. When the display shows Confirm to delete all readings?, push the Delete softkey. hpo064.jpg View Profiles Saved in Sequence Mode To view measurement data that is saved in Sequence mode: 1. Turn the rotary switch to VIEW memory. 2. Push M until MEMORY - SEQUENCE shows on the upper left corner of the display. The Load profile menu shows on the display. 3. Use  and  to highlight a profile, and push the View softkey. 4. View the memory items, and push the Next softkey to view next page as required. 5. Use 1 to cycle through these four data sets: mΩ.V, Dis.V, VDC, VAC, and Ripple. hpo065.jpg 4-2 MyFlukeStore Shop for Fluke products online at: www. .com 1.888.610.7664

Section	Page
BT510 Users Manual	1
Warranty	2
Table of Contents	3
List of Tables	5
List of Figures	6
1. Product Overview and Specifications	7
Introduction	7
Contact Fluke	7
Product Overview	7
Standard Equipment	9
Safety Information	11
Keys and I/O Terminals	14
LCD Display	16
Specifications	17
General Specifications	17
Accuracy Specifications	18
Records Capacity	19
2. Setup	20
Introduction	20
Tilt Stand	20
Belt Strap	21
Adjust Display Contrast	22
Set Language	22
Set Date and Time	22
Turn On/Off Beep	23
AutoHold and AutoSave Modes	23
Set Auto Power Off Time	24
View Device Information	25
Reset to Factory Mode	25
View Memory Usage Information	25
3. Use the Product	26
Introduction	26
Switch Between Meter Mode and Sequence Mode	26
Use a Profile in Sequence Mode	28
Manage Profiles	28
Create a Profile	29
Edit a Profile	30
Edit a Profile During Creation	30
Modify a Profile During Measurement	30
Load a Profile	30
Load a Profile When Switched to Sequence Mode	31
Load a Profile During Measurement in Sequence Mode	31
Make Measurements	32
Test Battery Internal Resistance and Voltage or Strap Resistance	32
Battery Test Probes	33
View Test Readings on the Screen	34
Measure Strap resistance in sequence mode	35
Set Measurement Range	35
Save Battery Test Readings	35
Erase Test Readings	35
Activate Low-Pass Filter for Resistance Measurement	36
Set Measurement Thresholds	36
How the Thresholds Work	37
Measure Discharge Voltage	38
Make Measurements	38
Typical Display	38
Measure DC Voltage	39
Set Measurement Range	39
Save DC Voltage Readings	39
Measure AC Voltage	40
Measurement Range	40
Save AC Voltage Readings	40
Measure Ripple Voltage	41
Set Measurement Range	41
Save Ripple Voltage Readings	41
Measure Voltage with TL175	42
4. View Memory	43
Introduction	43
View Data Saved in Meter Mode	43
Delete Data Saved in Meter Mode	43
View Profiles Saved in Sequence Mode	44
Delete Profiles Saved in Sequence Mode	45
5. Connection to PC	46
Introduction	46
Connect the Product to PC	46
6. Maintenance	48
Introduction	48
Install or Replace the Battery Pack	50
Replace the Fuse	51
Replace the Probe Tips	52
Zero Calibration	53
Clean the Product	54
Charge the Battery	54