Foxconn A76GMV English Manual - Page 36

Fox Intelligent Stepping CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc. Fox Intelligent Stepping CPU Clock Adjust [200] CPU Multiplier Adjust [Auto] Current CPU Speed : 3000MHz Help Item CPU-NB HT Link Speed [Auto] Current FSB/HTT Speed : 2000MHz CPU-NB Multiplier Control [Auto] Current CPU-NB Speed : 2000MHz Memory Speed Mode Current DRAM Speed [Auto] : N/A , 800MHz GFX Engine Clock Override PCIE Clock Abjust Spread Spectrum [Disabled] [100] [Enabled] 3 Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help F9:Optimized Defaults ► CPU Clock Adjust This option is used to adjust the CPU clock. ► CPU Multiplier Adjust This option is used to adjust the CPU Clock Ratio. Multiply CPU clock with this ratio, you can get the CPU speed. Increase this ratio may overclock your CPU. This option will be valid if your CPU ratio is unlocked and will be displayed only if your CPU is supporting this feature. ► CPU-NB HT Link Speed HT stands for HyperTransport bus. The CPUNB HT Speed option controls the physical speed of the CPU to Northbridge HT link. The physical speed of the link is determined by multiplying the CPU clock with the CPUNB HT Speed setting. ► CPU-NB Multiplier Control This item is used to select CPU-NB Multiplier run as Auto or Manual mode. Select [Auto] for CPU-NB default speed. Select [Manual], then CPU-NB speed is manually selected according to the setting of "CPUNB Multiplier Adjust". ► Memory Speed Mode This item is used to enable/disable provision of DRAM timing by SPD device. The Serial Presence Detect (SPD) device is a small EEPROM chip, mounted on a memory module. It contains important information about the module's speed, size, addressing mode and various other parameters, so that the motherboard memory controller (chipset) can better access the memory device. Select [Auto] for SPD enable mode. Select [Limit], the DRAM speed will not exceed the specified value listed in the "Memory Speed Adjust" item. If SPD value is faster than "Memory Speed Adjust" value, it will run at the specified "Memory Speed Adjust" speed. Otherwise, SPD value is selected. Select [Manual], then DRAM speed is manually selected according to the set value of "Memory Speed Adjust". ► GFX Engine Clock Override This item allows you to enable/disable GFX Engine Clock Override support. 29