Foxconn G41AP English Manual. - Page 37
► Memory Timing by SPD
View all Foxconn G41AP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
3 North Bridge Configuration CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc. North Bridge Configuration North Bridge Chipset Configuration Help Item ► Video Function Configure [Press Enter] Memory Remap Feature [Enabled] PCI MMIO Allocation:4GB To 3328MB DRAM Frequency [Auto] Memory Timing by SPD [Enabled] Memory Hole [Disabled] Initate Graphic Adapter [PEG/PCI] IGD Graphics Mode Select [Enabled, 64MB] IGD GTT Graphic smemory size [No VT mode, 2MB] PEG Port [Auto] Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help F9:Optimized Defaults ► Video Function Configure Press to go to its submenu. ► Memory Remap Feature This item is used to enable/disable memory remap feature. Its mainly for if you have a 64bit OS and 4GB of RAM. Basically it allows you to remap the overlapped PCI memory above the total physical memory. ► DRAM Frequency This item is used to adjust the DRAM frequency. Select [Auto] for SPD enable mode. You also can select a value manually such as [800 MHz]. ► Memory Timing by SPD This item is used to enable/disable provision of DRAM timing by SPD device. The Serial Presence Detect (SPD) device is a small EEPROM chip, mounted on a memory module. It contains important information about the module's speed, size, addressing mode and various other parameters, so that the motherboard memory controller (chipset) can better access the memory device. ► Memory Hole This item is used to determine whether the 15M-16M address field of memory is reserved for the ISA expansion card. ► Initate Graphic Adapter This item is used to choose the initate graphics controller which will be used as the primary boot device. ► IGD Graphics Mode Select This item is used to select the amount of system memory used by internal graphics device. ► PEG Port This item is used to enable/disable PCI Express graphics port. 30