Frigidaire AEQ8000FS Installation Instructions - Page 7

DRYER DOOR REVERSAL INSTRUCTIONS Be sure to wear gloves while reversing the door assembly. You will need a #2 square head drive screwdriver, a Phillips head screwdriver and pliers. 1. Open the dryer door. 2. Remove the two screws that secure the door hinge to the front panel. Remove the bottom screw first. Support the door assembly firmly before removing the top screw. 7. Remove the two hinge attachment screws, one square plug, two round plugs and one metal strike from the inner door. Hinge attachment screw Round plug Square plug Hinge attachment screw Metal strike Round plug Remove bottom screw first 3. Hold the door near the top and bottom and lift to remove the door. 4. Place door assembly face down on a padded, flat surface. 5. Pull out the two round plugs and slide the rectangular plug up and out of the front panel. Use care to avoid scratching the surface or damaging the plugs. Reinstall the plugs in Step 9. 8. Rotate the hinge and reattach it to the opposite side of the inner door. 9. Dispose of the old metal strike and install the new strike (included in the literature pack) in the opposite side of the inner door. Reinstall the round plugs and square plug in the holes left by the hinge and hinge screws. 10. Remove the hinge cutout plug. Rotate it and install it on the opposite side of the outer door. Rectangular Round plug plug Round plug 6. Remove the five longer screws (1 through 5) and the two shorter screws (6 and 7) that attach the inner door to the outer door. Do not remove any other screws at this time. Separate the inner door from the outer door. Hinge cutout plug 11. Reattach the inner door to the outer door using the seven screws removed in Step 6. 12. Holding the door at the top and bottom, insert the hinge post in the "T" slot in the front panel and lower to align the screw holes. While supporting the door, install the two screws removed in Step 2. Install the top screw first. 6 7 "T" Hinge Slot Post 13. Close the door. 7