Frigidaire FAH126R2T Use and Care Manual - Page 7

Air Conditioner Features (continued) TO OPERATE ON FAN ONLY: Auto Temp Hi Med Lo Heat Fan Speed Cool Energy Saver Fan Only Mode Temp/Timer Temp/Timer Timer Sleep Check Filter Remote Sensing DO THIS: LIGHT ON PRESS MODE BUTTON CHOOSE FAN ONLY YOU WILL SEE: Auto Temp Hi Med Lo Heat Fan Speed Cool Energy Saver Fan Only Mode Temp/Timer Temp/Timer Timer Sleep Check Filter Remote Sensing Note: Use this function only when cooling is not desired, such as for room air circulation. You can choose any fan speed you prefer,EXCEPT AUTO FAN. During this function, the display will show the actual current temperature, not the set temperature as in the cooling mode. Fan Only cannot be selected when the unit is in the 'Remote Sensing' Mode. (On those units with that feature). TO USE THE ENERGY SAVER FEATURE: LIGHT ON YOU WILL SEE: Auto Temp Hi Med Lo Heat Fan Speed Cool Energy Saver Fan Only Mode Temp/Timer Temp/Timer Timer Sleep Check Filter Remote Sensing DO THIS: PRESS MODE BUTTON CHOOSE ENERGY SAVER Auto Temp Hi Med Lo Heat Fan Speed Cool Energy Saver Fan Only Mode Temp/Timer Temp/Timer Timer Sleep Check Filter Remote Sensing Note: In this mode, the fan will continue to run for 3 minutes after the compressor shuts off. The fan then cycles on for 2 minutes at 10 minute intervals until the room temperature is above the set temperature, at which time the unit cooling system starts again. TIMER-DELAY START/STOP FEATURE: Auto Temp Hi Med Lo Heat Fan Speed Cool Energy Saver Fan Only Mode Temp/Timer Temp/Timer Timer Sleep Check Filter Remote Sensing FIRST DO THIS: PRESS TIMER BUTTON THEN DO THIS: PRESS TEMP/TIMER BUTTON YOU WILL SEE THE TIME CHOSEN: Auto Temp Hi Med Lo Heat Fan Speed Cool Energy Saver Fan Only Mode Temp/Timer Temp/Timer Timer Sleep Check Filter Remote Sensing LIGHT ON V Note 1: For Delay Stop, the unit must be in the ON position. Note 2: For Delay Start, the unit must be in the OFF position. To adjust timer setting, tap or hold the UP arrow ( ) or DOWN arrow (v) to change the delay time by .5 hour increments up to 10 hours, then by 1 hour increments up to 24 hours. The control will count down the timer remaining until start (8, 7.5, 7, etc.). The Delay Start mode automatically selects cooling with maximum Fan Speed. The temperature maintained will be the same as previously set. To change the set temperature, press "COOL" then Up or Down arrows until the desired temperature is indicated on the display. After 5 seconds, the control will automatically change the display back to the hours remaining until the unit will start/stop. Turning the unit "ON" or "OFF" at any timer will cancel the Delay Start/Stop function. The delay Start/Stop feature will work until the unit either starts or stops. Once this has happened then the above steps have to be repeated again. 7