Frigidaire FAH126R2T Use and Care Manual - Page 9

Air Conditioner Features (continued) HEATING FEATURE (on some models): YOU WILL SEE: Auto Temp Hi Med Lo Heat Fan Speed Cool Energy Saver Fan Only Mode Temp/Timer Temp/Timer Timer Sleep Check Filter Remote Sensing DO THIS: PRESS MODE BUTTON SELECT HEAT Auto Temp Hi Med Lo Heat Fan Speed Cool Energy Saver Fan Only Mode Temp/Timer Temp/Timer Timer Sleep Check Filter Remote Sensing Note: This feature can be used with any combination of FAN Speeds, Timer, or Sleep Modes. When in the "Heat" Mode, the fan will run continuously while heat is needed. The temperature will automatically be maintained anywhere between 55°F (13°C) and 80°F (27°C). When the room set temperature is satisfied, the fan will cycle off and on to circulate and sample the room air. TO TURN UNIT OFF: YOU WILL SEE: Auto Temp Hi Med Lo Heat Fan Speed Cool Energy Saver Fan Only Mode Temp/Timer Temp/Timer Timer Sleep Check Filter Remote Sensing DO THIS: PRESS ON/OFF BUTTOT Auto Temp Hi Med Lo Heat Fan Speed Cool Energy Saver Fan Only Mode Temp/Timer Temp/Timer Timer Sleep Check Filter Remote Sensing FAULT CODES Auto Temp Hi Med Lo Heat Fan S peed C ool E nergy S aver Fan Only Mode T e m p /T i m e r T e m p /T i m e r T imer S leep C he c k F ilte r R emote S ens ing If the display reads "AS", a sensor has failed. Contact your Authorized Frigidaire Service Center Auto Temp Hi Med Lo Heat Fan S peed C ool E nergy S aver Fan Only T e m p /T i m e r T e m p /T i m e r Mode T imer S leep C he c k F ilte r R emote S ens ing If the display reads "HS", a sensor has failed. Contact your Authorized Frigidaire Service Center Auto Temp Hi Med Lo Heat Fan S peed C ool E nergy S aver Fan Only Mode T e m p /T i m e r T e m p /T i m e r T imer S leep C he c k F ilte r R emote S ens ing If the display reads "ES", a sensor has failed. Contact your Authorized Frigidaire Service Center ADDITIONAL THINGS YOU SHOULD KNOW Now that you have mastered the operating procedure, here are more features in your control that you should know. ? The Remote Control will operate all the control panel features, follow the same instructions. ? ! The "Cool "circuit has an automatic3 minute time delayed start if the unit is turned off and on quickly. This prevents overheating of the compressor and possible circuit ! breaker tripping. The fan will continue to run during this time. ? The control will maintain any set temperature between 60F and 90F degrees (cooling), 55F and 80F (heating). ? The control is capable of displaying temperature in degrees Fahrenheit or degrees Celsius. To convert from one to the other, press and hold the Up and Down Temperature Selection Pads at the same time for 3 seconds. 9