Frigidaire FARE4044MW Installation Instructions (English, Español, Fr - Page 16

INSTALLATION INSTRUCTIONS General installation 1 Connect the exhaust duct to the outside exhaust system (see pages 6 through 8). Use of a 4" (102 mm) clamp (item A) is recommended to connect the dryer to the exhaust vent system. Use metal foil tape to seal all other joints. 2 Use a carpenter's level to level your dryer front-toback and side-to-side. For front-to-back leveling, place bottom edge of the level on the seam between the top panel and side panel. For side-to-side leveling place the bottom side of the level flush to the side panel. 3 Use adjustable pliers to adjust the leveling legs so the dryer is level front-to-rear and side-to-side, and stable corner-to-corner. 4 Press down on alternate corners and sides and feel for the slightest movement. Adjust the appropriate leg(s) so the dryer sits solidly on the floor on ALL four legs. Keep the leveling leg extension at a minimum for best performance of the dryer. IMPORTANT Be sure the power is off at a circuit breaker/fuse box before plugging the power cord into an outlet. 5 Plug the power cord into a grounded outlet. Grounding type wall receptacle Do not, under any circumstances, cut, remove, or bypass the grounding prong. a A b Power cord with 3-prong grounded plug 6 Turn on the power at the circuit breaker/fuse box. 7 Read the Use & Care Guide provided with the dryer. It contains valuable and helpful information that will save you time and money. 8 If you have any questions during initial operation, please review the "Avoid Service Checklist" in your Use & Care Guide before calling for service. 9 Place these instructions in a location near the dryer for future reference. raise lower c d 16