Frigidaire FAS226R2A Installation Instructions - Page 3

Window Mounting 1 Remove Chassis 1. Pull down front panel and remove filter. (See FIG. 1). 2. Lift front upwards and place to one side. FIG. 1 FIG. 2 2 Install Top Angle and Side Bracket 1. Attach foam gasket to top angle above holes as shown in FIG. 6. FIG. 6 3. Locate the four front screws and remove. These screws will be needed to re-install the front later. (See FIG.2) 4. Pry away front from cabinet sides as per photo (see FIG.3) 5. Gently lift front off unit and place to one side (See FIG.4). 2. Install top angle and side retainers to cabinet as shown in FIG. 6. FIG. 3 FIG. 4 6. Remove shipping crews from top of unit and also on the side by the base if installed. 7. Hold the cabinet while pulling on the base handle, and care- fully remove the unit. 8. Add two foam inserts to holes in top of cabinet where shipping screws were removed from. Assemble Window 3 Filler Panels 1. Place cabinet on floor, a bench, or a table. 2. Slide "I" section of window filler panel into side retainer on the side of the cabinet (see Figures 7-8). Do both sides. FIG. 7 PLASTIC FRAME WINDOW FILLER PANEL 9. Your unit may come with internal packaging.THIS PACKAGING MUST BE REMOVED PRIOR TO INSTALLING THE AIR CONDITIONER BACK INTO THE CABINET. (See FIG. 5).. Internal Packaging FIG. 5 FIG. 8 3 SIDE RETAINER TOP VIEW AIR CONDITIONER CABINET PLASTIC FRAME LOCKING "I" SECTION WINDOW SCREW HOLE FILLER PANEL