Frigidaire FCM07A04K Complete Owner's Guide - Page 27

Before You Call

Page 27 highlights

BEFORE YOU CALL 1-800-944-9044 (United States) 1-800-265-8352 (Canada) Visit our web site at www.frigidaire.com CONCERN CAUSE AUTOMATIC ICE MAKER Ice maker is not making any ice. • Ice maker wire signal arm is in the "up" or OFF position. • Ice maker power switch is Off. • Ice maker has small cube caught in mechanism. Ice maker is not making enough ice. • Saddle valve on cold water pipe is clogged or restricted by foreign material. • Ice maker is producing less ice than you expect. • Check to see if water dispenser is dispensing slower than normal. • Freezer control is set too warm. Ice maker will • Ice maker wire signal arm not stop mak- is being held down by ing ice. some item in the freezer. Ice cubes are freezing to- • Ice cubes are not being used frequently enough. gether. • Ice cubes are hollow (partially frozen cubes with water inside). • Freezer control is set too warm. DISPENSER (Ice & Water) Dispenser will • Dispenser lock out is not dispense engaged. ice. • There is no ice in the bin to be dispensed. • The refrigerator doors are not completely closed. • Dispenser paddle has been pressed too long and the dispenser motor has overheated. Ice dispenser is jammed. • Ice has melted and frozen around auger due to infrequent use, temperature fluctuations, and/or power outages. • Ice cubes are jammed between ice maker and back of ice container. SOLUTION • Move wire signal arm to the "down" or ON position (side mounted). • Turn power switch to On ("I") position (rear mounted). • Remove small cube from ice maker. The ice and water filter cartridge may be clogged. Replace filter cartridge. • Turn off household water line valve. Remove valve. Ensure that valve is not a self-piercing saddle valve. Clean valve. Replace valve if necessary. • Side mounted ice maker should produce 4 to 4.5 pounds (approximately 4 quarts) of ice every 24 hours. A rear mounted ice maker should produce 3 to 4 pounds (approximately 3½ quarts) of ice every 24 hours. Quick Ice option should produce up to 50% more ice every 24 hours. • If it is, replace the ice and water filter cartridge. • Set freezer control to colder setting to improve performance of the ice maker. Allow 24 hours for temperature to stabilize. • Move item and release wire signal arm. Remove any ice cubes that are frozen together over the wire signal arm. • Remove ice container and discard ice from container. Ice maker will produce fresh supply. • The ice and water filter cartridge may be clogged. Replace filter cartridge. • Set freezer control to colder setting. Allow 24 hours for temperature to stabilize. • Press and hold control lock for three seconds. • See the "Ice maker is not making any ice" section above. • Be sure the refrigerator doors are completely closed. • The motor overload protector will reset in about three minutes and then ice can be dispensed. • Remove ice container, thaw, and empty the contents. Clean container, wipe dry, and replace in proper position. When new ice is made, dispenser should operate. • Remove ice cubes that are jamming the dispenser. 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30

27
BEFORE YOU CALL
Visit our web site at
www.frigidaire.com
1-800-944-9044
(United States)
1-800-265-8352
(Canada)
CONCERN
CAUSE
SOLUTION
AUTOMATIC ICE MAKER
Ice maker is
not making any
ice.
Ice maker wire signal arm is
in the “up” or OFF position.
Ice maker power switch
is Off.
Ice maker has small cube
caught in mechanism.
Saddle valve on cold
water pipe is clogged
or restricted by foreign
material.
Move wire signal arm to the “down” or ON
position (side mounted).
Turn power switch to On (“I”) position
(rear mounted).
Remove small cube from ice maker. The
ice and water filter cartridge may be
clogged. Replace filter cartridge.
Turn off household water line valve.
Remove valve. Ensure that valve is not
a self-piercing saddle valve. Clean valve.
Replace valve if necessary.
Ice maker is
not making
enough ice.
Ice maker is producing
less ice than you expect.
Check to see if water
dispenser is dispensing
slower than normal.
Freezer control is set too
warm.
Side mounted ice maker should produce
4 to 4.5 pounds (approximately 4 quarts)
of ice every 24 hours. A rear mounted
ice maker should produce 3 to 4 pounds
(approximately 3½ quarts) of ice every 24
hours. Quick Ice option should produce up
to 50% more ice every 24 hours.
If it is, replace the ice and water filter
cartridge.
Set freezer control to colder setting to im-
prove performance of the ice maker. Allow
24 hours for temperature to stabilize.
Ice maker will
not stop mak-
ing ice.
Ice maker wire signal arm
is being held down by
some item in the freezer.
Move item and release wire signal arm.
Remove any ice cubes that are frozen
together over the wire signal arm.
Ice cubes are
freezing to-
gether.
Ice cubes are not being
used frequently enough.
Ice cubes are hollow
(partially frozen cubes
with water inside).
Freezer control is set too
warm.
Remove ice container and discard ice from
container. Ice maker will produce fresh supply.
The ice and water filter cartridge may be
clogged. Replace filter cartridge.
Set freezer control to colder setting. Allow
24 hours for temperature to stabilize.
DISPENSER (Ice & Water)
Dispenser will
not dispense
ice.
Dispenser lock out is
engaged.
There is no ice in the bin
to be dispensed.
The refrigerator doors are
not completely closed.
Dispenser paddle has
been pressed too long
and the dispenser motor
has overheated.
Press and hold control lock for three
seconds.
See the “Ice maker is not making any ice”
section above.
Be sure the refrigerator doors are com-
pletely closed.
The motor overload protector will reset in
about three minutes and then ice can be
dispensed.
Ice dispenser is
jammed.
Ice has melted and
frozen around auger
due to infrequent use,
temperature fluctuations,
and/or power outages.
Ice cubes are jammed
between ice maker and
back of ice container.
Remove ice container, thaw, and empty
the contents. Clean container, wipe dry,
and replace in proper position. When new
ice is made, dispenser should operate.
Remove ice cubes that are jamming the
dispenser.