Frigidaire FEQ1442ES Operating Instructions - Page 2

Cycle Selection (Con't) Delicate Select this Auto Dry cycle for knits and delicate items. Quick Select this cycle to quickly dry a small load made up of just a few items. It provides approximately 20 minutes of tumbling followed by a 10-minute cool down period. Touch Up Select Touch Up to help remove wrinkles from clean and dry items that were not taken from the dryer at the end of the cycle, have been stored in crowded closets or drawers, or unpacked from luggage following a trip. It provides approximately 10 minutes of tumbling followed by a 5-minute cool down period. Timed Dry To manually select the drying time for any load, turn the knob to a numbered setting. Drying times from 15 to 90 minutes are available in 15-minute increments. You will not be able to select a cycle or dryness level. Timed Dry is recommended when using the No Heat option. Note: To change cycles, press PAUSE/CANCEL twice. Temperature Selection For best results, follow the fabric care label instructions on items to be dried. High is recommended for sturdy fabrics. Medium is recommended for wrinkle free, permanent press and lightweight fabrics. Low is recommended for delicate fabrics. No Heat should only be used with a Timed Dry setting to dry items containing feathers, down, foam rubber, plastics or rubber-like materials; to freshen clothing, pillows or blankets; or to dust draperies. Note: Using No Heat in any Auto Dry cycle will result in long drying times and /or wet loads at the end of the cycle. To avoid fire hazard, do not use heat to dry items containing feathers or down, foam rubber, plastics, or similarly textured, rubber-like materials. Use the No Heat setting only. Cycle Adjustments A suitable combination of dryness level and options will automatically be displayed for each cycle. The settings can be changed before the cycle is started. Those adjustments will automatically be remembered each time that cycle is selected. If a dryness level or option is not recommened for a cycle, the indicator will not light. See the "Dryer Settings Chart" for more details. If changes are attempted after the cycle starts, the status lights will blink and the signal will beep 3 times. The cycle must be paused before the settings can be changed. Dryness Level To change the dryness level, press DRYNESS until the desired selection is made. Select Normal for most loads. Occasionally a load may seem too damp or overdried at the end of the cycle. To increase drying time for similar loads in the future, select More Dry. For loads requiring less drying time, select Less Dry. Select Damp Dry for items you wish to partially dry before hanging or ironing. Note: To prevent over-drying, not every dryness level is available with every cycle. Options To select an option, press OPTIONS until the indicator for the desired option flashes and press SELECT. If an option is not available for a cycle, the indicator will not light. Follow the same steps to delete an option. The Cycle Signal will sound at the end of the cycle and periodically during Press Saver. Select Press Saver if the dried load might not be removed promptly at the end of the cycle. The dry load will continue tumbling without heat for 30 minutes to help reduce wrinkling. When the Cycle Signal is selected, a beep will be heard periodically. The load may be removed any time during Press Saver. Dryer Features Control (Control Lock) To avoid having someone accidentally start or stop the dryer, press OPTIONS and SELECT at the same time until the Control (Control Lock) indicator is lighted. To remove the control lock, press OPTIONS and SELECT again. Status Lights The following indicators may be lighted during the cycle: • Drying • Cool Down • Press Saver • Clean Lint Filter • Control (Control Lock) PN 134420600C (0412)