Frigidaire FFFH17F2QW Complete Owner's Guide - Page 4

IMPORTANT SAFETY INSTRUCTIONS WARNING Other Precautions • To defrost appliance, always unplug unit first. • Never unplug the unit by pulling on the power cord. Always grip the plug firmly and pull straight out from the receptacle. • Turning the control to OFF turns off the compressor, but does not disconnect power to other electrical components. FIRST STEPS 3" (75 mm) 3" (75 mm) 3" (75 mm) 3" (75 mm) 1" (25 mm) Leveling The appliance must have all bottom corners resting firmly on a solid floor. The floor must be strong enough to support a fully loaded unit. FIRST STEPS This Use & Care Guide provides general operating instructions for your model. Use the unit only as instructed in this Use & Care Guide. Before starting the unit, follow these important first steps. Location Choose a place that is near a grounded electrical outlet. For the most efficient operation, the appliance should be located where surrounding temperatures will not exceed 110°F (43°C). Temperatures of 32°F (0°C) and below will NOT affect operation. Additional compressor heaters are not recommended. 3" (75 mm)  NOTE It is VERY IMPORTANT for your appliance to be level in order to function properly. If the unit is not leveled during installation, the door/lid may be misaligned and not close or seal properly, causing cooling, frost or moisture problems. To level Upright Units: After discarding crating screws, use a carpenter's level to level the appliance from front to back. Adjust the plastic leveling feet in front, ½ bubble higher, so that the door closes easily when left halfway open. To level Chest Units: If needed, add metal or wood shims between feet pads and floor. Allow space around the unit for good air circulation. Leave a 3 inch (75 mm) space on all sides of the unit for adequate circulation. 3" (75 mm) 3" (75 mm) Installation 4