Frigidaire FFID2423RS Complete Owner's Guide - Page 11

Care And Cleaning - installation

Page 11 highlights

CARE AND CLEANING Spray Arm varies by model (2) (3) Glass Trap WARNING Burn Hazard Allow heating element to cool before cleaning the interior. Failure to do so can result in burns. Outer Door - Clean outer door with warm soapy water and a dishcloth or sponge. Rinse (1) with clean water and a dry cloth. Do not use harsh cleaners. Glass Trap Removal To empty the glass trap: 1. Grasp the glass trap's handle and rotate it 900 clockwise while pressing down on the center of the wash arm. 2. Grab the spray arm in the center and lift the spray arm and glass trap assembly up and out form the dishwasher. 3. Tip the assembly over an appropriate container and tap it to empty the glass trap. OR, separate the glass trap - pull the glass trap handle toward you, then up, then further toward you to slide it away from the rest of the assembly; empty it into an appropriate container; then slide the glass trap back into the assembly. Inside - The inside of the dishwasher and filter are self-cleaning with normal use. If needed, clean around the tub gasket area with a damp cloth. The filter is self-cleaning. A glass trap located in the center of the filter is designed to collect pieces of broken glass, straws, bones and pits. Overfill Protector- keeps dishwasher from overfilling and is located in the left front corner of the tub. • Clean occasionally with household cleaner containing vinegar or bleach to dissolve any buildup. • Overfill Protector should move up and down freely about one inch. If it does not move, lift and clean underneath. 4. Place the assembly back into position, press down on the arm at the center and rotate the glass trap handle 900 counterclockwise being sure the glass trap ends in the orientation shown in the image above. To avoid damage to your unit make sure the spray arm and glass trap are fully snapped in place. NOTE See Installation Instructions for more details on disconnecting and restoring service to your dishwasher. NOTE Hard water may cause lime deposit buildup on the interior of the dishwasher. For cleaning instructions see "Removing Spots and film" section. 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16

11
CARE AND CLEANING
NOTE
See Installation Instructions for more details
on disconnecting and restoring service to
your dishwasher.
°
To empty the glass trap:
1.
Grasp the glass trap’s handle and rotate it
90
0
clockwise while pressing down on the
center of the wash arm.
2.
Grab the spray arm in the center and lift
the spray arm and glass trap assembly up
and out form the dishwasher.
3.
Tip the assembly over an appropriate
container and tap it to empty the glass
trap.
OR, separate the glass trap - pull
the glass trap handle toward you, then
up, then further toward you to slide it
away from the rest of the assembly;
empty it into an appropriate container;
then slide the glass trap back into the
assembly.
4.
Place the assembly back into position,
press down on the arm at the center
and rotate the glass trap handle 90
0
counterclockwise being sure the glass
trap ends in the orientation shown in the
image above.
To avoid damage to
your unit make sure the spray arm
and glass trap are fully snapped in
place.
Spray Arm varies
by model
Glass Trap
Glass Trap Removal
(1)
(2)
(3)
Outer Door -
Clean outer door with warm
soapy water and a dishcloth or sponge.
Rinse
with clean water and a dry cloth.
Do not use
harsh cleaners.
Inside -
The inside of the dishwasher and
filter are self-cleaning with normal use.
If
needed, clean around the tub gasket area with
a damp cloth.
The filter is self-cleaning.
A
glass trap located in the center of the filter
is designed to collect pieces of broken glass,
straws, bones and pits.
NOTE
Hard water may cause lime deposit buildup
on the interior of the dishwasher.
For
cleaning instructions see “Removing Spots
and film” section.
Overfill Protector-
keeps dishwasher
from overfilling and is located in the left front
corner of the tub.
Clean occasionally with household cleaner
containing vinegar or bleach to dissolve
any buildup.
Overfill Protector should move up and
down freely about one inch.
If it does not
move, lift and clean underneath.
°
WARNING
Burn Hazard
Allow heating element to cool before
cleaning the interior.
Failure to do so can result in burns.