Frigidaire FFPA1022T1 Complete Owner s Guide - Page 15

Operating Instructions function Press the " " button to switch between degree Fahrenheit and degrees Celsius. Timer mode How to delay startup Plug in the unit, so the unit turns to standby. Press the "timer on" button, the screen will display " "and "H". Tap or hold the UP arrow ( ) or the DOWN arrow ( ) to change delay start timer at 0.5 hour increments up to 10 hours, then at 1 hour increments up to 24 hours. After 2 seconds, the setting will be memorized. The control will count down the time remaining until startup. The unit will start up in the mode as previously set. To cancel the setting, press the "timer on" button again. How to delay shutdown You can delay shutdown when the unit is on. Press the "timer off" button, the screen displays " "and "H". Tap or hold the UP arrow ( ) or the DOWN arrow ( ) to change delay stop timer at 0.5 hour increments up to 10 hours, then at 1 hour increments up to 24 hours. After 2 seconds, the setting will be memorized, and the display will show the time remaining until the unit shuts down. To cancel the setting, press the "timer off" button again. Fault Code If the screen on the unit displays "AS", the room temperature sensor has failed. Contact your Authorize Frigidaire Service Center. If the screen on the unit displays "ES", the pipe temperature sensor has failed. Contact your Authorize Frigidaire Service Center. If the screen on the unit displays "P1", the water collection tank inside the unit should be full. Refer to the "Drainage Instructions" on Page 16 for more instructions to drain the successive condensate. If error repeats, contact your Authorize Frigidaire Service Center.