Frigidaire FFPA1022T1 Complete Owner s Guide - Page 6

Installation Instructions Installation Instructions EXHAUSTING HOT AIR In the Cool Mode the appliance must be placed close to a window or opening so that the warm exhaust air can be ducted outside. First position unit on a flat floor and make sure there's a minimum of 12″clearance around the unit, and is within the vicinity of a single circuit outlet power source. 1. Extend either side of the hose(Fig.1) and screw the hose to connector A (Fig.2). 2. Extend the other side of the hose and screw it to connector B (Fig. 3). 3. Install the connector B into the unit (Fig.4). 4. Affix the connector A into the window slider kit and seal. (Fig.5&6) Vertical window Window Slider Kit Minimum:26.6″(67.5cm) Maxmum:48.5″(123cm) Fig.5 Horizontal window Window Slider Kit Minimum:26.6″(67.5cm) Maxmum:48.5″(123cm) Fig.6 The hose can be extended from its original length of 15″up to 59″,but it is the best to keep the length to minimum required. Also make sure that the hose does not have any sharp bends or sags.(Fig.7) Fig.7 Extend the side of hose Fig.1 Fig.2 FFPA0822T1、FFPA1022T1 Fig.3 FFPA1222T1、FFPH1222T1 FFPA1422T1、FFPH1422T1 Fig.4 Slide onto FFPA0822T1、FFPA1022T1 1 Slide onto 2 Lock FFPA1222T1、FFPH1222T1 FFPA1422T1、FFPH1422T1