Frigidaire FFTA1033Q1 Installation Instructions - Page 3

Installation Instructions 4. Prepare the wall sleeve for installation of the new unit per the following Brand instructions. #1 Emerson #2 Fedders #3 Fedders or Friedrich #4 General Electric/Hotpoint #5 Sears or Carrier(51S Series) #6 Whirlpool #7 Whirlpool #8 White-Westinghouse/Frigidaire/ Carrier(52F Series) 15Ǝ Deep 193 4Ǝ Deep 16 3 4Ǝ Deep 167 8Ǝ Deep 185 8Ǝ Deep 171 8Ǝ Deep 23Ǝ Deep 16Ǝ + 171 2Ǝ Deep #9 White-Westinghouse/Frigidaire 22Ǝ Deep 5. Identify your wall sleeve type and follow the instructions for that type in the following pages. IMPORTANT This unit's increased performance characteristics result from having two rear air intakes. It is very important that these installation instructions are followed so your unit can operate at maximum efficiency. If there is an existing sleeve, and there is an existing rear grille, it needs to be replaced by one that has been shipped with the unit in the accessory kit. FOR INCREASED EFFICIENCY, UTILIZE THE PROVIDED LOUVERED REAR PANEL Installation of new grille provided with unit 1. Remove the existing grille. 2. Place the grille included with the new air conditioner towards the rear of the sleeve. 3. Mark through the hole positions. 4. Drill through the sleeve flanges with a 1/8" drill bit. 5. Attach the new grille with self-threading screws and washers(not included). 6. It is VERY IMPORTANT that the grille is placed exactly as shown. 7. Most decorative exterior grilles may be left in place as long as the proper interior air direction grille is installed. NOTE: If the provided grill is not used, it may lead to product damage and possible failure. 3