Frigidaire FGEF306TMF Complete Owner's Guide (English) - Page 16

SETTING OVEN CONTROLS SETTING LOCKOUT FEATURE The pad controls the Lockout feature. The Lockout feature automatically locks the oven doors, the control panel and the cooktop. It does not disable the Minute Timer or the interior oven lights. To activate the Lockout feature 1. Press and hold for 3 seconds. 2. After 3 seconds "Loc" and "Control" will appear, a beep will sound, "UPPER", "LOWER" and "DOOR" will flash in the display. Once the oven door is locked the "DOOR" will stop flashing and remain on along with the "Loc", "Control" and the icon will appear. To reactivate normal operation: 1. Press and hold for 3 seconds. A beep will sound. The "UPPER", "LOWER" and "DOOR" will flash in the display until the oven door has completely unlocked and the icon will disappear. 2. The unit is again fully operational.  NOTE The surface elements cannot be activated when the Lockout feature is active (see the section: The electronic surface element control (ESEC)). SETTING SILENT CONTROL OPERATION The DELAY START and SELF CLEAN pads control the Silent Control operation feature. The Silent Control operation feature allows the oven control to be operated without sounds or beeps whenever necessary. If desired the control can be programmed for silent operation and later returned to operating with all the normal sounds and beeps. To change control from normal sound operation to silent control operation 1. To tell if your range is set for normal or silent operation press and hold DELAY START. "-- --" will appear and "DELAY" will flash in the display. After 6 seconds "bEEP On" or "bEEP OFF" will appear in the display. 2. Press SELF CLEAN to switch between normal sound operation and silent operation mode. The display will show either "bEEP On" or "bEEP OFF". Note: If "bEEP On" appears, the control will operate with normal sounds and beeps. If "bEEP OFF" appears, the control is in the silent operation mode. 3. Press START to accept the change or press CANCEL to reject the change. Note: The control will always beep at the end of a minute timer and will beep when a set temperature has been reached, even if the control is set to silent operation. 16 SETTING TIMER The TIMER ON.OFF pad controls the Timer feature. The Timer serves as an extra timer in the kitchen that will beep when the set time has run out. It does not start or stop cooking. The Timer feature can be used during any of the other oven control functions. Refer to "Minimum and Maximum Control Pad Settings" for time amount settings. To set the Timer (example for 5 minutes) 1. Press TIMER ON.OFF. "-- --" will appear in the display. 2. Use the number pads to set the desired time in the display; press 5. 3. Press START. The time will begin to count down with "5:00" in the display. Note: If START is not pressed the timer will return to the time of day after 25 seconds. 4. When the set time has run out, "End" will show in the display. The clock will sound with 3 beeps every 5 seconds until TIMER ON.OFF is pressed. To cancel the Timer before the set time has run out 1. Press TIMER ON.OFF. The display will return to the time of day. SETTING ADD 1 MINUTE FEATURE The ADD 1 MINUTE pad is used to set the Add 1 Minute feature. When the ADD 1 MINUTE pad is pressed, 1 minute is added to the Timer feature if this feature is already active. If the Timer feature is not active and the ADD 1 MINUTE pad is pressed, the Timer feature will become active and will begin counting down from 1 minute.