Frigidaire FGF319KB Installation Instructions (All Languages) - Page 6
write if you have inquiries about your range product - replacement parts
View all Frigidaire FGF319KB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
30" GAS RANGE INSTALLATION INSTRUCTIONS (For Gas Venturi models with Electric Ignition) 1" Flame Burner Baffle Model and Serial Number Location The serial plate is located under the lift-up cooktop. When ordering parts for or making inquires about your range, always be sure to include the model and serial numbers and a lot number or letter from the serial plate on your range. Your serial plate also tells you the rating of the burners, the type of fuel and the pressure the range was adjusted for when it left the factory. Oven Burner Tube Before You Call for Service Check to make sure the house fuses or circuit breakers for your range are not blown or open. Refer to the Avoid Service Checklist and operating instructions in your Owner's Guide. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance. Air Shutter Lock Screw Air Shutter Orifice Hood Refer to the warranty in your Owner's Guide for our toll-free service number and address. Please call or write if you have inquiries about your range product and/ or need to order parts. Care, Cleaning and Maintenance Refer to the Owner's Guide for operating and cleaning instructions. 9. Air Shutter-Oven Burner The approximate flame length of the oven burner is 1 inch (distinct inner, blue flame). To determine if the oven burner flame is proper, remove the oven bottom and burner baffle and set the oven to bake at 300°F. To remove the oven bottom, remove oven hold down screws at rear of oven bottom. Pull up at rear, disengage front of oven bottom from oven front frame, and pull the oven bottom out of the oven. Remove burner baffle so that the burner flame can be observe. If the flame is yellow in color, increase air shutter opening size. If the flame is a distinct blue, reduce the air shutter opening size. To adjust loosen lock screw, reposition air shutter, and tighten lock screw. Replace oven bottom. If removing the range is necessary for cleaning or maintenance, shut off gas supply. Disconnect the gas and electrical supply. If the gas or electrical supply is inaccessible, lift the appliance slightly at the front and pull out away from the wall. Pull only as far as necessary to disconnect the gas and electrical supply. Finish removing the unit for servicing and cleaning. Reinstall in reverse order making sure to level the range and check gas connections for leaks. See Anti-Tip Instructions for proper anchoring instructions. 10. Make Sure Range is Level. Level the range by placing a level horizontally on an oven rack. Check diagonally from front to back, then level the range by either adjusting the leveling legs or by placing shims under the corners of the range as needed. 11. After installation is complete, make sure all controls are left in the OFF position. 6