Frigidaire FGGF3032MW Complete Owner's Guide (English) - Page 32
Setting Oven Controls, self-clean, Problem, Possible Causes, Solutions, Self-cleaning., before
View all Frigidaire FGGF3032MW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
BEFORE YOU CALL • Solutions to common problems Problem bake or self-clean did not start at the time expected. Strong odor from range or smells hot. Possible Causes The time of day is incorrect. Self-clean was started for the first times or from a new range. Solutions Set clock with correct time of day before adding a delay start setting. See "Setting the clock" in Setting Oven Controls section. It is normal for odors to occur during self-clean, especially during the first self-clean cycle. It is recommend to ventilate the kitchen area. Open any windows and if available turn on an exhaust fan or overhead range hood during the self-clean cycle. Unable to remove Oven door locks immeadiately items from oven after after setting self-clean. starting self-clean. Press cancel to stop self-clean. Wait for the oven door to unlock. Once unlocked, remove any items left in the oven, close the oven door and set for self-clean again. Oven door did not Oven is too hot. unlock after the selfclean cycle. Self-clean feature will not start. Incorrect control setting. Oven door open. Self-clean will not restart after being cancelled. The control has determined oven is too hot to restart selfclean (some models). Allow about 1 hour after the self-clean cycle for the oven to cool enough before the oven door will unlock. Carefully follow the prepartion and programming instructions under Self-cleaning. The oven door must lock before the self-clean cycle will start. Be sure the oven door is closed before starting self-clean. In some cases after cancelling self-clean, you may be required to wait up to 4 hours before the self-clean feature may be used again. Watch display for any messages. Soil not completely removed after selfcleaning cycle. Heavy soils. Clean time too short or spillovers were left inside oven. Set self-clean feature for maximum cleaning time. Remove any excessive spillovers from oven before starting self-clean. Carefully follow prepartion instructions under "Self-cleaning". Failure to clean soil from the oven frame, the door liner outside the oven door gasket and the small area at the front center of the oven bottom. These areas are not within the self-cleaning area, but get hot enough to burn on residue. Clean these areas before starting a self-clean cycle. Burned-on residue may be cleaned with a stiff nylon brush and water or a nylon scrubber. Be careful not to damage the oven gasket. Interrupted by power outage. Once power is restored restart self-clean. Powdered ash inside This is normal. The the oven cavity after temperature of the self-clean self-clean cycle. feature turned dirt to ash. Wait for the oven to completely cool. Wipe away any residue or powdered ash from the oven interior using a clean damp cloth or paper towel. Oven rack finish is dull or discoloring. Oven racks left inside oven during self-clean. Remove all oven racks from oven before starting self-clean. Clean after removing from the oven using a mild, abrasive cleaner following manufacturer's instructions. Thoroughly rinse and dry. Oven rack no longer slides in or out of oven easily. Oven racks left inside oven during self-clean. Remove all oven racks from oven before starting self-clean. To ease rack movement, remove from oven and clean if needed. Then apply a small amount of vegetable oil to a paper towel and wipe oil on edges of oven racks. Do not use lubricant spays. 32