Frigidaire FGHS2655PF Use and Care Manual - Page 29
Concern, Cause, Solution
View all Frigidaire FGHS2655PF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
BEFORE YOU CALL CONCERN CAUSE AUTOMATIC ICE MAKER (Continued) Freezer ice maker will not • Ice maker wire signal arm is being held down stop making ice (select by a package in the freezer that has fallen models). against ice maker. Ice cubes are freezing • Ice cubes are not being used frequently enough together. or interruption of power for prolonged time. • Ice cubes are hollow (shells of ice with water inside). The hollow cubes break open in the bin and leak their water onto existing ice, which causes it to freeze together. DISPENSER (Ice & Water) Dispenser will not dispense ice. • Dispenser lock out is engaged. • There is no ice in the bin to be dispensed. • The refrigerator doors are not completely closed. Ice dispenser is jammed. • Dispenser paddle has been pressed too long and the dispenser motor has overheated. • Ice has melted and frozen around auger due to infrequent use, temperature fluctuations, and/or power outages. • Ice cubes are jammed between ice maker and back of ice container. Dispenser will not dispense water. • Dispenser lock out is engaged. • Water filter not seated properly. • Water filter is clogged. • Household water line valve is not open. SOLUTION • Move any item or frozen ice cubes that may block the signal arm from being in the off or upward position. See Automatic Ice Maker-Freezer section in manual. • Remove ice container and discard ice. The ice maker will produce fresh supply. Ice should be used at least twice weekly to keep the cubes separated. • This generally occurs when the ice maker does not get enough water. This is usually the result of a clogged water filter or restricted water supply. Replace the water filter and if the condition still occurs check for a Saddle Valve, water valve not turned on all the way or kinked water supply line. • Press and hold control lock for three seconds. • See the "Ice maker is not making any ice" section above. • Be sure the refrigerator doors are completely closed. • The motor overload protector will reset in about three minutes and then ice can be dispensed. • Remove ice container, thaw, and empty the contents. Clean container, wipe dry, and replace in proper position. When new ice is made, dispenser should operate. • Remove ice cubes that are jamming the dispenser. • Press and hold control lock for three seconds. • Remove and reinstall the water filter. Be sure to push the filter firmly so that you hear it lock solidly into position. • Replace filter cartridge. Be sure to remove protective caps and push the filter firmly so that you hear it lock solidly into position. • Open household water line valve. See CONCERN column AUTOMATIC ICE MAKER. 29