Frigidaire FGHS2655PF Use and Care Manual - Page 8

DOOR REMOVAL INSTRUCTIONS 3 Remove the two bottom hinge screws and hinge if necessary. Door Hinge Assembly Closer Pin Screws Hinge Adjustable Hinge (some models) To reinstall the refrigerator door, reverse the above steps. To remove the freezer top hinge cover: 1 Remove the two screws from each cover over the top door hinges. 2 Lift hinge cover straight up and off. Front Cover Screws Top Hinge Cover Rear Cover Screw Hinge Screws Multi-Wire Cable 2 Trace lightly around the hinge with a pencil. This makes reinstallation easier. 3 Detach the water tube from the connector located below the freezer door. The connector releases when you press its outer sleeve inward. 4 Remove the screws from the top hinge and pull the multi-wire cable through it. Lift the door off of the bottom hinge. 5 Remove the two bottom hinge screws and hinge if necessary. To Disconnect 1. Press outer ring against face of fitting 2. Pull to remove tube To Connect Insert tube and push until mark touches face of fitting Door Closer Pin Water Line Tubing Hinge Hinge Assembly Screws Adjustable Hinge (some models) Door Top Hinge To remove the freezer door: 1 Detach the multi-wire cable connector located above the top hinge. Grasp both sides of the connector firmly and pull apart. Hinge Assembly Water Line Tubing Screws Non-Adjusting Hinge (some models) 6 Lay the door on its side to avoid damage to the water tube extending from the bottom hinge. To reinstall the freezer door, reverse the above steps. CAUTION Be sure doors are set aside in a secure position where they cannot fall and cause personal injury. 8