Frigidaire FPEF3077QF Installation Instructions - Page 3

Electrical Connection Requirements - electric range

Get Frigidaire FPEF3077QF PDF manuals and user guides View all Frigidaire FPEF3077QF manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

30" (762 mm) ELECTRIC RANGE INSTALLATION INSTRUCTIONS (For 4 Wire, 60 Hz. Systems) location of the screw holes, shown in template. B. Drill Pilot Holes and Fasten Bracket - Drill a 1/8" (3 mm) pilot hole where screws are to be located. If bracket is to be mounted to the wall, drill pilot hole at an approximate 20° downward angle. If bracket is to be mounted to masonry or ceramic floors, drill a 5/32" (4 mm) pilot hole 1-3/4" (44 mm) deep. The screws provided may be used in wood or concrete material. Use a 5/16" (8 mm) nutdriver or flat head screwdriver to secure the bracket in place. (32 mm) (32 mm) (17 mm) 2. Electrical Connection Requirements Avoid fire hazard or electrical shock. Failure to follow this warning may casue serious injury, fire, or death. Plug the range power cable (4 conductors) into a 4 conductor range outlet. Outlet must be properly grounded and in accordance with the Canadian Electrical Code (CSA Standard (C22.1 Part 1 -- latest edition) -- and any local electrical code requirements. Locate outlet 6" (152 mm) above the floor in the wall behind the range. Grounding Instructions For personal safety, this appliance must be properly grounded. For maximum safety, the power cord must be plugged into an electrical outlet that is correct voltage, is correctly polarized and properly grounded in accordance with local codes. C. Level and Position Range - Level range by adjusting the (4) leveling legs with a wrench. Note: Aminimum clearance of 1/8" (3 mm) is required between the bottom of the range and the leveling leg to allow room for the bracket. Use a spirit level to check your adjustments. Slide range back into position. Visually check that rear leveling leg is inserted into and fully secured by the Anti-Tip Bracket by removing lower panel or storage drawer. For models with a warmer drawer or broiler compartment, grasp the top rear edge of the range and carefully attempt to tilt it forward. Power supply cord with 4-prong grounding plug 240V grounded wall receptacle It is the personal responsibilty of the consumer to have the appropiate outlet with the correct, properly grounded wall receptacle installed by a qualified electrician. 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
3
30" (762 mm) ELECTRIC RANGE INSTALLATION INSTRUCTIONS
(For 4 Wire, 60 Hz. Systems)
location of the screw holes, shown in template.
B.
Drill Pilot Holes and Fasten Bracket
- Drill a 1/8" (3 mm)
pilot hole where screws are to be located.
If bracket is to
be mounted to the wall, drill pilot hole at an approximate
20° downward angle. If bracket is to be mounted to
masonry or ceramic floors, drill a 5/32" (4 mm) pilot hole
1-3/4" (44 mm) deep. The screws provided may be used
in wood or concrete material.
Use a 5/16" (8 mm) nut-
driver or flat head screwdriver to secure the bracket in
place.
C.
Level and Position Range
- Level range by adjusting the
(4) leveling legs with a wrench. Note: Aminimum clearance
of 1/8" (3 mm) is required between the bottom of the
range and the leveling leg to allow room for the bracket.
Use a spirit level to check your adjustments.
Slide range
back into position.
Visually check that rear leveling leg
is inserted into and fully secured by the Anti-Tip Bracket
by removing lower panel or storage drawer. For models
with a warmer drawer or broiler compartment, grasp the
top rear edge of the range and carefully attempt to tilt it
forward.
2. Electrical Connection Requirements
Avoid fire hazard or electrical shock. Failure
to follow this warning may casue serious injury, fire, or death.
Plug the range power cable (4 conductors) into a 4 conductor
range outlet. Outlet must be properly grounded and in
accordance with the Canadian Electrical Code (CSA Standard
(C22.1 Part 1 -- latest edition) -- and any local electrical code
requirements.
Locate outlet 6" (152 mm) above the floor in the wall behind
the range.
Grounding Instructions
For personal safety, this appliance must be properly grounded.
For maximum safety, the power cord must be plugged into an
electrical outlet that is correct voltage, is correctly polarized
and properly grounded in accordance with local codes.
It is the personal responsibilty of the consumer to have the
appropiate outlet with the correct, properly grounded wall
receptacle installed by a qualified electrician.
240V grounded
wall receptacle
Power supply
cord with 4-prong
grounding plug
(32 mm)
(32 mm)
(17 mm)