Frigidaire FPEH3077RF Installation Instructions - Page 6
Four Conductor Wire Connection to Range, Three Conductor Wire Connection to Range - canada
View all Frigidaire FPEH3077RF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
30" ELECTRIC RANGE INSTALLATION INSTRUCTIONS This appliance is manufactured with the frame grounded by connection of a grounding strap between the neutral power supply terminal and the frame. If used in USA, in a new branch circuit installation (1996 NEC), mobile home or recreational vehicle, where local code do not permit grounding through neutral (white) wire or in Canada; remove the grounding strap from the frame and cut the other end, near the neutral terminal. Connect the appliance in usual manner. Three Conductor Wire Connection to Range If local codes permit connection of the frame grounding conductor to the neutral wire of the copper power supply cord (see Figure 8): 1. Remove the screws from the access plate at the lower right end of the rear cover to expose range terminal connection block. 2. Using the nuts supplied in the literature package, connect the neutral of the copper power supply cord to the center silver-colored terminal of the terminal block, and connect the other wires to the outer terminals. Match wires and terminals by color (red wires connected to the right terminal, black wires connected to the left terminal) (see Figure 8). 3. Replace the terminal cover and replace the screws. Silver Colored Terminal Red Wire Terminal Block Black Wire Cord Mounting Plate Neutral (White Wire) Grounding Strap Four Conductor Wire Connection to Range Where local codes does NOT permit connection of the frame grounding conductor to the neutral wire of the copper power supply cord (see Figure 9): 1. Remove the screws from the access plate at the lower right end of the rear cover to expose range terminal connection block. 2. Remove the grounding strap from the terminal block and from the appliance frame. 3. Using the nuts supplied with the literature package, connect the ground wire (green) of the copper power supply cord to the frame of the appliance with the ground screw, using the hole in the frame where the ground strap was removed (see Figure 9). 4. Connect the neutral of the copper power supply cord to the center silver-colored terminal of the terminal block, and connect the other wires to the outer terminals. Match wires and terminals by color (red wires connected to the right terminal, black wires connected to the left terminal). 5. Replace the terminal cover and replace the screws. Silver Colored Terminal Block Terminal Red Wire Black Wire 1 1/8" (2.9cm) Dia. Direct Connection Hole. Punch Out Knockout for 1 3/8" (3.5cm) Dia. Cord Kit Hole. A User Supplied Strain-relief Must Be Installed at This Location Neutral (White Wire) Ground (Bare Copper Wire) To 240 V Receptacle A User Supplied Strain-relief Must Be Installed at This Location. 1 1/8" (2.9 cm) To 240 V Dia. Direct Receptacle Connection Hole. Punch Out Knockout for 1 3/8" (3.5 cm) Figure 8 Dia. Cord Kit Hole. NOTE: Be sure to remove the supplied grounding strap. Figure 9 6