Frigidaire FPIC3677RF Complete Owner s Guide - Page 10
Setting Induction Surface Controls
View all Frigidaire FPIC3677RF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
SETTING INDUCTION SURFACE CONTROLS The Electronic Surface Element Control The Electronic Surface Element Control includes digital display windows. The control provides a numeric digital setting for the surface element positions on the cooktop. These settings work the same way as normal knob setting indicators work except the settings are displayed in digital windows (Figs. 1 thru 8). The available Display Settings The control provides various heat levels from Hi (Fig. 2) to Lo (Fig. 4) and OFF (Fig. 1). The settings between 9.0 and 1.5 decrease or increase in increments of .5 (1/2). Hot Element Indicator Message (HE) After using any of the element positions the cooktop will become very hot. Even after turning the control knob to OFF, the cooktop will remain hot for some time. The control monitors the temperature of the cooktop and displays the message "HE" (hot element) warning when the cooktop is still too hot to touch (See Fig. 5). If the HE message appears in the window, the control can still be turned ON again for use. Power Boost Indicator Message (Pb) When an induction zone is first set at Hi, the Power Boost feature will turn on (see Fig. 6). The Power Boost feature is used to bring large quantities of water or food to cooking temperature at the fastest speed possible. The Power Boost feature will give you up to 139% power output for a set amount of time (approx. 10 min). Error Indicator Message An error message will be displayed at power up (or after a power failure) if ANY of the surface control knobs were left in the ON positions. If any control knobs were turned on during a power failure of more than 10 seconds, the display will show an "Er" message. If a power failure should occur, be sure to set all of the surface control knobs to the OFF position. This will reset the surface controls. The induction zones are equipped with a pot detection system. If the controls are activated and the detection system cannot find any pot of the correct material on the zone, it will flash its power level for 3 minutes. After flashing for 3 minutes, the digital display will show an "- -" message. Error message "C" will only appear during a fault condition. Error messages "Er" and "- -" may appear on display after an invalid action by the user. Set surface control knob to the OFF position to reset the control. Once the surface controls have been set to the OFF positions, the surface controls should return to normal operation. If the surface controls do not function and the "C", "Er", or "- -" message remains in any display after following these procedures, contact your authorized servicer for assistance. Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5 Fig. 6 Control knobs shown are typical only. Surface cooking settings Use the chart to determine the correct setting for the type of food you are preparing. Note: The size and type of cookware used will influence the setting needed for best cooking results. Recommended Setting for Surface Element Setting Type of Cooking HIGH (HI) Start most foods; bring water to a boil and pan broiling. MEDIUM HIGH Continue a rapid boil; frying, deep fat (8-10) frying. MEDIUM (6) Maintain a slow boil; thicken sauces and gravies; steaming vegetables. MEDIUM LOW Keep foods cooking; poaching and (2 - 4) stewing. LOW (LO) Keep warm, melting and simmering. 10