Frigidaire FRA124HT2 Installation Instructions (All Languages) - Page 2
How to Install - dimensions
UPC - 012505274077
View all Frigidaire FRA124HT2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Installation Instructions How to Install 1. Identify the wall-sleeve brand for your installation, from the chart below. Brand Width Wall Sleeve Dimensions Height White-Westinghouse Frigidaire Carrier (52F Series) General Electric/Hotpoint 251 2 251 2 251 2 26 151 4 151 4 151 4 155 8 Whirlpool Fedders/Emerson Sears/Kenmore Emerson/Fedders 25 7 8 27 25 3 4 26 3 4 16 1 2 16 3 4 16 7 8 15 3 4 Carrier (51S Series) Friedrich 25 3 4 27 16 7 8 16 3 4 Depth 16, 17 1 2 or 22 16, 17 1 2 or 22 16, 17 1 2 or 22 15 7 8 171 8 or 23 16 3 4 or 19 3 4 18 5 8 15 18 5 8 16 3 4 IMPORTANT All wall sleeves used to mount the new Air Conditioner must be in sound structural condition and have a rear grille that securely attaches to sleeve, or rear flange that serves as a stop for the Air Conditioner. CAUTION: When installation is complete, replacement unit MUST have a rearward slope as shown in Fig.1. 2. Remove old Air Conditioner from wall sleeve and prepare wall sleeve as follows: Clean interior (do not disturb seals). Wall sleeve must be securely fastened in wall before installing Air Conditioner. Drive more nails or screws through sleeve, into wall, if needed. Retouch wall sleeve painted surface if needed. 3. If not existing, drill a 3/16" clearance hole for grounding screw through left side of wall sleeve, in a clear area about 3 inches maximum back from front edge of sleeve, using grounding screw and toothed washer. Pull loose end of ground wire out front of sleeve, and temporarily bend it down and around lower edge of sleeve (Fig.2). This ground wire will later be attached to frame of air conditioner once it is installed. Wall sleeve 1/4" to 5/16" REAR UNIT FRONT Wall sleeve to unit sleeve grounding Max. Hole Fig.1 2 LEVEL Fig.2