Frigidaire FRA124HT2 Installation Instructions (All Languages) - Page 5
Fedders - installation manual
UPC - 012505274077
View all Frigidaire FRA124HT2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Installation Instructions Wall Sleeve Brands: #2 Fedders 19-3/4" Deep 1. Remove existing rear grille as shown on Page 3 of this manual and replace with provided louvered rear panel. Install as shown here. NOTE: You may need to drill holes in flange of existing sleeve to match 80º new rear grille Rear Louvers 50º 50º 80º Top View 2. Attach (2) 4 1 2 " x 3 1 2" x 11 2" centering/support blocks one on each side wall. Place in center of side wall with the tapered end facing the opening. 3. Cut (2) 17" Tapered Spacer Blocks as shown below into two pieces. 17" 1" 3/4" Tapered Spacer Block Cut Here 4" protection Paper Backing 4. The 4" section is placed in front of the rib on base with the tapered end facing the back of the sleeve. The remaining portion will be placed behind the rib again sloping toward the rear of the sleeve. This helps induce a rearward slope on the unit. 5. Attach (1) 1" x 3/8" x 25" long seal in the center at the top of the sleeve. Remove the backing paper and press into position. 6. Attach (2) 1" x 3/8" x 14" seals to the left and right sides of the sleeve. 7. Cut (2) 1" x 3/8" x 25" long seals to 14" long each and attach to the vertical sections of the grille as shown. 8. Gently slide unit into sleeve. 9. Before sliding all-the-way back, remove 2nd screw from front on left side of unit. 10. Remove the plastic washer from the screw. 11. Screw and attach the other end of the ground wire from sleeve to the unit as shown in picture. Make sure that the toothed washer is against the cabinet. 12. Slide the unit completely to the rear to ensure a good seal, making sure the ground wire does not become tangled. 13. Seal & Frame the unit as described on the last page of these instructions. 14. If you have difficulty with mounting the grill to the sleeve, follow the instructions for direct mounting on Page 13. 5