Frigidaire GLEQ2152ES Operating Instructions - Page 3

ERROR CODE CHART If the dryer stops, the status lights flash, the signal beeps and a code is displayed, an error has occured. Press PAUSE/CANCEL twice. Consult the Error Code Chart below or the "Avoid Service Checklist" in the Owner's Guide for the possible cause and solution. Make necessary corrections, then select a cycle and press START. If the dryer stops, the status lights flash again, the beeping continues and the code reappears, please contact service for assistance. Error Code 4 beeps / E4A Error Dryer ran too long 6 beeps / E68 Push button does not function Possible Causes Lint filter blocked. Ventilation system clogged. Dryer overloaded. Push button held too long or wedged in the control panel. Solutions Remove lint; wash lint filter to remove softener sheet residue Clean out ventilation system. Reduce load size. Press buttons lightly and release. Disengage button. DRYER SETTINGS CHART AVAILABLE CYCLE SETTINGS - These temperatures, dryness levels and options are available with the following cycles: Estimated drying time *** Temperatures High Medium-High Medium Low No Heat Dryness Level Towels 60 minutes * ** Normal Perm Press Delicate Quick 50 minutes 40 minutes 20 minutes 30 minutes * * * * ** ** ** Bulky 45 minutes * Timed Dry 15 to 90 minutes * More Dry Normal Dry * * * Less Dry * Damp Dry Options Shrink Guard Press Saver Cycle Signal * Factory setting * Available settings * * * ** Not recommended * * * * * * *** Estimated cycle duration is based on normal dryness level and factory settings. PN 134431300A (0501)