Frigidaire PLCF489GC Installation Instructions - Page 7

40" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS (Models with Electric Ovens and Gas Cooktop) Tighten all connections if necessary to prevent gas leakage in the cooktop or supply line. Check alignment of valves after connecting the cooktop to the gas supply to be sure the manifold pipe has not been moved. Disconnect the range and its individual shutoff valve from the gas supply piping system during any pressure testing of the system at test pressures greater than 1/2 psig (3.5 kPa or 14" water column). LP/Propane Gas Conversion This appliance can be used with Natural Gas or Propane Gas. It is shipped from the factory for use with natural gas. If you wish to convert your range for use with LP/Propane gas, use the supplied fixed orifices; they are contained in a special bag along with instructions marked "FOR LP/ PROPANE GAS CONVERSION", located on the back of the range, close to the appliance regulator valve. The conversion must be performed by a qualified installer, LP supplier or service technician in accordance with the installation instructions furnished with this range and all codes and requirements of all local codes and requirements. Failure to follow instructions could result in serious injury or property damage. The qualified agency performing this work assumes responsibility for the conversion. Moving the Appliance for Servicing and Cleaning Turn off the range line fuse or circuit breakers at the main power source, and turn off the manual gas shut-off valve. Make sure the range is cold. Remove the service drawer and open the oven door. Lift the range at the front and slide it out of the cut-out opening without creating undue strain on the flexible gas conduit. Isolate the range from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig (3.5kPa or 14" water column). Make sure not to pinch the flexible gas conduit at the back of the range when replacing the unit into the cutout opening. Replace the drawer, close the door and switch on the electrical power and gas to the range. If the pressure regulator is connected to rigid piping, the regulator must be disconnected before moving the appliance. Reassemble in reverse order (see figure 9). Failure to make the appropriate conversion can result in personal injury and property damage. Any additions, changes or conversions required in order for this appliance to satisfactorily meet the application needs must be made by an authorized Sears Service Center, Distributor or Qualified Agency. 7