Frigidaire PLGFZ397GC Use and Care Guide - Page 11

Setting Oven Controls Setting the Clock The CLOCK pad is used to set the clock. The clock may be set for 12 or 24 hour time of day operation. The clock has been preset at the factory for the 12 hour operation. When the appliance is first plugged in, or when the power supply to the appliance has been interrupted, the clock in the display will flash (See Fig. 1). INSTRUCTIONS To set the clock (example below for 1:30): PRESS Fig. 1 DISPLAY 1. Press . "CLO" will appear in the display (See Fig. 2). 2. Press pads to set the time of day to 1:30 (See Fig. 2 Fig. 3). Press (See Fig. 4). . "CLO" will disappear and the clock will start Fig. 3 Changing between 12 or 24 hour time of day display: 1. Press and hold for 6 seconds untill "12h" or "24h" appears for 6 seconds in the display. Fig. 4 2. Press to switch between the 12 and 24 hour time of day display. "12h" or "24h" will be displayed (See Figs. 5 or 6). 3. Press to accept the desired change or press to reject or Fig. 5 the change. 4. Reset the correct time as described in To set the clock above. Please note that if the 24 hour time of day mode was chosen, the clock will now display time from 00:00 through 23:59 hours. Fig. 6 Setting Silent Control Operation The DELAY START and FLEX CLEAN pads control the Silent Control operation feature. The Silent Control operation feature allows the oven control to be operated without sounds or beeps whenever necessary. If desired the control can be programmed for silent operation and later returned to operating with all the normal sounds and beeps. INSTRUCTIONS PRESS DISPLAY To change control from normal sound to silent control operation: 1. To tell if your range is set for normal or silent operation press for 7seconds and hold for 6 seconds. (See Fig. 7) Fig. 7 2. Press to switch between normal sound operation and silent operation mode. The display will show either "SP" (See Fig. 8) or " - -" (See Figs. 2 or 3). Fig. 8 If "SP" appears (See Fig. 2), the control will operate with normal sounds and beeps. If " - -" appears (See Fig. 9), the control is set for silent operation mode. 3. Press to accept the change or press to reject the or Fig. 9 change. 11