Frigidaire PLGFZ397GC Use and Care Guide - Page 9

Setting Warming Drawer Controls Removing & Replacing the Warming Drawer To Set the Warming Drawer Control The control is used to select the temperature of the Warming Drawer. It is located on the control panel. To set the control, push in and turn the knob to the desired setting. The temperatures are approximate, and are designated by HI (high), MED (medium) and LO (low). To set the Warming Drawer control: 1. Turn the knob to select the desired temperature setting. 2. For best results, preheat the drawer before adding food. An empty drawer will preheat in approximately 15 minutes. 3. When done, turn the control to OFF. Warming Drawer Temperature Selection Recommended Warming Drawer food settings are shown in Fig. 3. If a particular food is not listed, start with the MED setting. If more crispness is desired, remove the lid or aluminum foil from the food. Most foods can be kept at serving temperatures on the MED setting. When a combination of foods are to be kept warm (for example, a meat with 2 vegetables and rolls) use the HI setting. To avoid heat loss, do not open the Warming Drawer while in use. Warming Drawer Indicator Light The Warming Drawer indicator light is located above the Warming Drawer control knob (See Fig. 2). It turns on when the control is set, and stays on until the control is turned off. The Warming Drawer will not operate during the Self-Clean cycle. Warming Drawer Recommended Food Settings Table Food Item Setting Bacon Hamburger Patties Poultry Pork Chops Fried Foods Pizza Gravies Casseroles Eggs Roasts (Beef, Pork, Lamb) Vegetables Biscuits Rolls, hard Pastries Rolls (soft) Empty Dinner Plates HI HI HI HI HI HI MED MED MED MED MED MED MED MED LO LO Fig. 3 Fig. 1 Fig. 2 Electrical Shock Hazard can occur and result in serious injury or death. Disconnect appliance from electric power before cleaning and servicing the Warming Drawer. To Remove and Replace the Warming Drawer (some models) To Remove the Warming Drawer: 1. Turn power off before removing the Warming Drawer. 2. Open the drawer to the fully opened position. 3. Locate glide lever on each side of drawer, pull up on the left glide lever and push down on the right glide lever (See Fig.1). 4. Pull the drawer away from the range. To Replace the Warming Drawer: 1. Pull the bearing glides to the front of the chassis glide (See Fig. 2). 2. Align the glide on each side of the drawer with the glide slots on the range. 3. Push the drawer into the range until levers "click" (approximately 2"). Pull the drawer open again to seat bearing glides into position. If you do not hear the levers "click" or the bearing glides do not feel seated remove the drawer and repeat steps 1 thru 3. This will minimize possible damage to the bearing glides. NOTE: The Warming Drawer will NOT operate while in the Self-Clean and "Oven Lockout" modes. 9