Fujitsu M4097D Operator's Guide - Page 74
Contents of the Setup Mode
UPC - 097564302930
View all Fujitsu M4097D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Contents of the Setup Mode This section describes the contents of the setup mode. No Item 1 Double feed check 2 Length check =No/10/15/20 mm 3 IPC pre-setting 4 Resetting of abrasion counter 5 Pick start time setting 6 Time-out limit setting 7 ADF front offset setting* 8 ADF back offset setting* 9 Flatbed offset setting* Description Selectable parameters Default Specifies the double feed detection. Double feed is detected by checking the No document length and/or paper thickness.** Specifies the document length to enable double feed detection sets the document length. Tolerance: No/10/15/20mm No Scanner automatically sets the recommended reading parameters. 3 sets of parameters are available when IPC-4D is not installed. Document: No Sharpen Darken No Charactor Copy Quality Resets the abrasion counter. - - Specifies the time from document Insertion to the start of picking. User can select the most comfortable Pick start time for the job. Time: 0.2 to 29.8 sec Specifies the time the scanner waits for the next document insertion after the last document was scanned. Time: 27 values from 1 to 1999 sec Specifies the horizontal and vertical offset Offset: of the front side image when using the H:-2 to +3 mm ADF. V:-2 to +3 mm Specifies the horizontal and vertical offset Offset: of the back side image when using the H:-2 to +3 mm ADF. V:-2 to +3 mm Horizontal and vertical offset of the FB image is specified. Offset: H:-2 to +3 mm V:-2 to +3 mm 1.0 sec 30 sec Offset: H: 0 mm V: 0 mm Offset: H: 0 mm V: 0 mm Offset: H: 0 mm V: 0 mm 7-2