Garmin Astro 430 Owner s Manual - Page 18

Dog Device Battery Replacement Instructions T5 Components Back plate À Power key Á Battery connector  Battery cover à Battery Ä Power connector Å Removing the Old Battery Before you replace the battery, you must remove all dirt, water, and debris from the device. You must also have a small Phillips screwdriver. 1 Remove the six screws from the outer edges of the back plate. NOTE: You should leave the two inner screws in place. 2 Pry off the back plate. 3 Disconnect the battery connector and power connector. 4 Remove the screws that secure the battery cover. 5 Remove the battery cover and the battery. Remember the orientation of the battery. You must install the new battery the same way. After you remove the old battery, contact your local waste disposal department to properly recycle the battery. Installing the New Battery Before you replace the battery, you must remove the old battery (Removing the Old Battery, page 14). You also must have a small Phillips screwdriver. You may need a small flat screwdriver. 1 Install the new battery using the same orientation as the old battery. The connector should face the end nearest the power key, and the bump Àwhere the wires connect to the battery Á should face toward the side with the charging clip contacts. 2 Replace the battery cover. 3 Replace the screws to secure the battery cover. 4 Connect the battery connector and power connector. You may need to use a flat screwdriver to help secure the connectors. 5 Select the power key to test the connections. When properly connected, a tone is emitted and the status LED blinks green. 6 Turn off the device. 7 Verify the gasket located inside the bottom cover is fully seated. 8 Replace the back plate. 9 Replace the six screws to secure the back plate. After you install the new battery, charge the collar completely. Replacing the T5 mini Dog Collar Device Battery Before you can replace the battery, you must remove all dirt, water, and debris from the device. You also need a small Phillips screwdriver and the security screwdriver included in the battery replacement kit. 1 Remove the screws from the L-shaped cover over the VHF antenna. 2 Pry off the L-shaped cover. 3 Remove the screws from the outer edges of the back plate. 4 Pry off the back plate. 5 Grip the battery connector wires close to the connector, and pull the connector perpendicular to the circuit board to disconnect the battery connector from the device. 6 Grip the power connector wires close to the connector, and pull the connector parallel to the circuit board to disconnect the power connecter from the device. 7 Remove the screws from the battery plate. 8 Remove the battery plate. 9 Remove the battery. The battery fits tightly. It may be necessary to pry the battery out of the back plate using a non-sharp, non-metal object. 10Install the new battery into the front enclosure with the label side of the battery facing up, and the leading edge of the battery placed under the charging contact ledge of the device. 11Replace the battery plate, and replace and tighten the two screws. 14 Appendix