Garmin Astro 430 Owner s Manual - Page 5
Setting Up the System, Device Overviews, Installing Batteries, Charging the Dog Collar Device - tracking system
View all Garmin Astro 430 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Introduction WARNING See the Important Safety and Product Information guide in the product box for product warnings and other important information. Setting Up the System You must set up the handheld device and the dog collar device before you can use the devices. 1 Install batteries in the handheld device (Installing Batteries, page 1). 2 Charge the dog collar device (Charging the Dog Collar Device, page 1). 3 Turn on the devices (Turning On the Devices, page 2). 4 If necessary, add the dog collar device to the handheld device (Pairing a Dog Collar to the Astro Device, page 4). 5 Acquire satellite signals (Acquiring Satellite Signals, page 2). Device Overviews Astro 430 Handheld Device NOTICE Avoid using a high-powered radio (greater than 5 watts) in close proximity to the handheld device. It may cause irreversible damage to the handheld device. MENU Select to open the menu for the active page. Select twice to open the main menu. ENTER Select to select options and acknowledge messages. BACK Select to cancel data entry or return to the previous menu or page. MARK Select to mark your current location. DOG Select to view the dog tracking page. Select to view or scroll through options and to move the map pointer. Locking the Keypad 1 Select . 2 Select OUT. Dog Collar Device NOTE: Your dog collar device may look different than the device pictured. GPS antenna À VHF antenna Á Power key  Display à Keypad Ä USB port (under weather cap) Å microSD™ card slot (under battery door) Æ Mounting spine Ç Battery cover D-ring È Keypad IN OUT MAP Select to zoom in on the map. Select to zoom out on the map. Select to view the map. Introduction VHF antenna À GPS antenna Á Power key  Status LED and flashing beacon LEDs à Installing Batteries The handheld device operates on two AA batteries (not included). Use NiMH or lithium batteries for best results. 1 Turn the D-ring counter-clockwise, and pull up to remove the cover. 2 Insert two AA batteries, observing polarity. 3 Replace the battery cover, and turn the D-ring clockwise. 4 Hold . 5 Select Setup > System > Battery Type. 6 Select Alkaline, Lithium, or Rechargeable NiMH. Charging the Dog Collar Device NOTICE To prevent corrosion, thoroughly dry the contacts on the collar and the surrounding area before connecting the charging clip. NOTE: Your dog collar device may look different than the device pictured. 1