Garmin GAD 43 Installation Manual - Page 25

Shield Termination on Backshell Assembly

Get Garmin GAD 43 PDF manuals and user guides View all Garmin GAD 43 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

Figure 3-3. Shield Termination on Backshell Assembly Prepare all of the shielded cables as shown in Figure 3-2. Refer to Figure 3-3 for details of the shield termination to the connector backshell. 1. At the end of the shielded cable (11), strip back a 2" maximum length of the jacket to expose the braid. Remove this exposed braid. Carefully score the jacket 1/4" to 5/16" from the end and remove the jacket to leave the braid exposed. NOTE Solder sleeves with pre-installed shield drains may be used instead of separate shield terminators and individual wires. 2. Connect a 20 or 22 AWG wire (13) to the exposed shield of the prepared cable assembly. (See Figure 3-2). AC 43.13 maybe a helpful reference for termination techniques. GAD 43 Installation Manual 190-00899-00 Page 3-5 Rev. B

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
GAD 43 Installation Manual
Page 3-5
190-00899-00
Rev. B
Figure 3-3. Shield Termination on Backshell Assembly
Prepare all of the shielded cables as shown in Figure 3-2. Refer to Figure 3-3 for details of the shield
termination to the connector backshell.
1.
At the end of the shielded cable (11), strip back a 2” maximum length of the jacket to expose the
braid. Remove this exposed braid. Carefully score the jacket 1/4” to 5/16” from the end and remove
the jacket to leave the braid exposed.
NOTE
Solder sleeves with pre-installed shield drains may be used instead of separate shield
terminators and individual wires.
2.
Connect a 20 or 22 AWG wire (13) to the exposed shield of the prepared cable assembly. (See Figure
3-2). AC 43.13 maybe a helpful reference for termination techniques.