Garmin GC 14 Installation Instructions - Page 3
Troubleshooting
![]() |
View all Garmin GC 14 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Installation With Encoder Diagram You can add more than one camera to your network when you use an encoder. GC 14 1 A fuse or circuit breaker (required, not included)1 12 Vdc power source BNC to BNC coaxial video cable (not included) Network cable Power-over-Ethernet isolation coupler (GPN 010-10580-10) Garmin Marine Network cable Axis® Q7424 Encoder (optional/not included) Compatible Garmin chartplotter Composite video ground loop isolator (not included) Troubleshooting Video Does Not Appear on the Chartplotter Screen • Verify all cables are firmly connected. • Verify the video cable is connected to the camera video output port. Image on the Chartplotter Screen is Dim or Dark • Verify the lens is clean. If necessary, wipe the lens with a soft, clean cloth. • If the camera is exposed to too much direct light, change the camera position or location. • Adjust the contrast on your chartplotter. See your chartplotter manual for instructions. 1 You must connect the camera power wire to the battery through a 1 A fuse or circuit breaker. If you omit a fuse or circuit breaker, the camera can malfunc tion. 3
![](/manual_guide/products/garmin-gc-14-installation-instructions-1323203/3.png)