Garmin GDL 39/GDL 39R GDL 39 User's Guide - Page 34

GDL 39R Location and Mounting

Get Garmin GDL 39/GDL 39R PDF manuals and user guides View all Garmin GDL 39/GDL 39R manuals
Add to My Manuals
Save this manual to your list of manuals

Page 34 highlights

3.4 GDL 39R Location and Mounting The GDL 39R is designed for mounting in a location remote from the cockpit. The GDL 39R uses the dSub connector wiring information in section 3.1.6 for the installer to create the necessary cable for connecting to the aircraft wiring. 1. Locate the proposed mounting position. Ensure that the cabling will reach the required connections with room to secure the cables in a safe manner. 2. Place the mounting plate in position and mark the location of the six mounting holes. 3. Drill holes for the mounting screws with the appropriately sized bit. 4. Attach the mounting plate with #8 flat head 100° screws (not supplied). 3-16 Garmin GDL 39 Portable ADS-B and GPS Receiver User's Guide 190-11110-00 Rev. G

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
3-16
Garmin GDL 39 Portable ADS-B and GPS Receiver User’s Guide
190-11110-00
Rev. G
3.4
GDL 39R Location and Mounting
The GDL 39R is designed for mounting in a location remote from the cockpit.
The GDL 39R uses the dSub connector wiring information in section 3.1.6 for the
installer to create the necessary cable for connecting to the aircraft wiring.
1.
Locate the proposed mounting position. Ensure that the cabling will reach
the required connections with room to secure the cables in a safe manner.
2.
Place the mounting plate in position and mark the location of the six
mounting holes.
3.
Drill holes for the mounting screws with the appropriately sized bit.
4.
Attach the mounting plate with #8 flat head 100° screws (not supplied).