Garmin GPSMAP 196 Yoke Mount Instructions   - Page 1

The long clamp adjustment knob shaft can protrude too far down when fully tightened onto larger type control shafts and center column arms, creating an obstruction or hazard. Use the short clamp adjustment knob to remove the obstruction. To replace clamp adjustment knobs: 1. Remove the rubber padding from the lower clamp by carefully Rubber Padding peeling it away to reveal the Allen screw. This screw secures the lower clamp to the long clamp adjustment knob. 2. Use the supplied Allen wrench to remove the screw, washer, and Allen Head Screw lower clamp from the long clamp Washer adjustment knob. 3. Remove the long clamp adjustment knob by turning it counter-clockwise. 4. Install the short clamp adjustment knob by turning it clockwise until it protrudes through the clamp frame. 5. Reassemble the washer and Allen screw onto the short clamp adjustment knob and tighten. Lower Clamp Short Clamp Adjustment Knob 6. Reinstall the rubber padding. NOTE: Verify the lower clamp is properly oriented in the clamp frame as illustrated. A cable clamp is provided on the top of the yoke mount to secure the 12-Volt adapter cable provided with the GPSMAP 196/296/396. If you intend to use your GPSMAP 196/296/396 primarily in an aircraft and not in an automobile, you can secure the cable with this clamp. Use of the clamp reduces the risk of loose wires becoming a hazard during operation of the aircraft controls. © Copyright 2005 Garmin Ltd. or its subsidiaries Garmin International, Inc. 1200 East 151st Street, Olathe, Kansas 66062, U.S.A. Garmin (Europe) Ltd. Unit 5, The Quadrangle, Abbey Park Industrial Estate, Romsey, SO51 9DL, U.K. Garmin (Asia) Corporation No. 68, Jangshu 2nd Road, Shijr, Taipei County, Taiwan www.garmin.com Printed in Taiwan Part Number 190-00603-00 Rev. B 4 GPSMAP 196/296/396 YOKE MOUNT INSTALLATION INSTRUCTIONS The GPSMAP 196/296/396 Yoke Mount comes fully assembled and includes: Allen Wrench GPSMAP 196/296/396 Cradle Short Clamp Adjustment Knob Long Clamp Adjustment Knob Cable Clamp WARNING: It is the sole responsibility of the owner/operator of the GPSMAP 196/296/396 to place this mount and secure the unit so that it will not interfere with the aircraft's operating controls and safety devices, or cause damage or personal injury in the event of an accident or turbulence. Do not mount the GPSMAP 196/296/396 in a place where the pilot or passengers are likely to impact it in an accident, collision, or turbulence. The mounting hardware provided by Garmin is not warranted against turbulence, collision damage, or related consequences. The yoke mount is packaged pre-assembled and includes a short clamp adjustment knob, a cable clamp, and Allen wrench. Larger yoke control shafts or center column arms require the short clamp adjustment knob for correct configuration. Refer to page 4 for instructions on changing adjustment knobs. The yoke mount is designed to fit the majority of conventional aircraft yokes and center column controls. When you remove this yoke mount from the package, it is configured for conventional aircraft yokes. If you have center column control, you must remove the clamp assembly from the rest of the yoke mount. Rotate the clamp 90o so that the open end of the clamp faces away from you and reattach it to the rest of the yoke mount. Refer to the illustrations and instructions on page 3. 1